Como Hacer Una Flor De Papel

Kawasaki Rose
6 1

Unfold steps 1 to 4 and this is the result.

7 Folding the rose begins with creating a grid on the paper at a 22.5 degree angle, 45 degree/2. Crease diagonals, and with thecoloured side up, valley fold left side to the diagonal. Repeat above. It is important to fold the correct side to the diagonal, as shown in the diagram.

2 Rotate 90 degrees and repeat steps 1 to 4Mountain fold only the bottom layer 8

3

Valley fold the tip of the front layer so that it is flush with the layer behind. Repeat behind.

4 Valley fold/unfold first two layers of paper.Repeat behind

Unfold and you should now have a grid on a 22.5 degree angle.

5 Valley fold/unfold first four layers of paper. I recommend that the folder fold at most two layers of paper at a a timeto avoid paper drift. The type of fold (valley or mountain) is unimportant at this point in folding

Kawasaki Rose 1/5 Designer: Toshikazu Kawasaki Diagrammed By: Winson Chan Revision: 2.1 Date:4/29/96

9

12

Fold along this mountain crease when done

1/3 2/3

Make the following mountain and valley folds. See enlargement. Notice the position of the horizontal crease. Repeat on allfour sides 10

Make the following mountain and valley folds. They are at 45 degrees relative to the grid. The square in the centre can be used as a guide. When these creases are complete, mountainfold along the crease indicated, the entire length of the paper 13

Form the two valley folds indicated

14 The paper should look like this after completing each set. Renforce each set of folds bycrimping along the darkened line. 11

Mountain fold the top point behind. Notice the location of the light gray area over the next three steps.

This is what one of the crimps looks like. Repeat onall four sets.

Kawasaki Rose 2/5 Designer: Toshikazu Kawasaki Diagrammed By: Winson Chan Revision: 2.1 Date: 4/29/96

15

17

Twist fold along the lines indicated. The next 2 steps...