Metal-edged ruler Butter knife Scissors or X-ACTO knife Cutting mat (optional) Multipurpose glue One brad CUT SOLID LINES Using scissors or an X-ACTO knifeand cutting mat, cut along solid lines of all pieces as instructed. SCORE DASHED LINES Using a ruler as a guide, run the back side of a butter knife firmly along all the dashed lines.
Cut outand score head piece. Make sure to cut the small slit on head and the ‘X’ on the back flap. Fold along score marks. Glue the ‘A’ tabs to the inside of the back flap. Insert brad through hole in theback of the head, from the inside pointing out.
Glue the ‘B’ tabs to the inside of the front of the head. The fold line in tab ‘B’ should align with the inner crease above the eyes.
Cut outcrown piece and glue the two ends together.
©2009 Curiosity Group www.curiositygroup.com
Apply glue to inside of tab ‘A’ and insert into the slot in head and fold back. Glue tab ‘B’ to theback of the head piece.
Cut out the ears along the outer grey line. Score along the dotted line. Glue and fold. Allow to dry, then cut out along the solid line on the ‘back’ side. Use an X-actoknife to cut the ‘X’ hole.
Cut out wing ‘A’ along the outer grey line. Score along the dotted lines. Glue and fold. Allow glue to dry then cut out along the solid line on the ‘front’ side. Repeat theproccess for wing ‘B’.
©2009 Curiosity Group
Cut out and score the body section. Insert wing ‘A’ into to the ‘V’ slit so that the side labled ‘A’ is facingforward. Fold down tab and glue to underside. Repeat with wing ‘B’ on opposite side.
Insert brad on head through ‘X’ hole in ears so that side labled ‘back’ is facing away from head. Next insert bradthrough the ‘X’ hole in the body and splay brad to secure.
Fold sides of body down and glue in place. For the final touches slightly curl the trunk up using your finger. For the tail, bend down...