Ingeniero

TD-W8901G
54M Wireless ADSL2+ Modem Router

Rev: 1.0.4
1910010194

COPYRIGHT & TRADEMARKS
Specifications are subject to change without notice.

is a registered trademark of

TP-LINK TECHNOLOGIES CO., LTD. Other brands and product names are trademarks or
registered trademarks of their respective holders.
No part of the specifications may be reproduced in any form or by any means orused to make any
derivative such as translation, transformation, or adaptation without permission from TP-LINK
TECHNOLOGIES CO., LTD. Copyright © 2009 TP-LINK TECHNOLOGIES CO., LTD. All rights
reserved.
http://www.tp-link.com

FCC STATEMENT

This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limitsare designed to pro-vide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not in-stalled and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation.If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the following
measures:
•

Reorient or relocate the receiving antenna.

•

Increase the separation between the equipment and receiver.

•

Connect the equipment intoan outlet on a circuit different from that to which the
receiver is connected.

•

Consult the dealer or an experienced radio/ TV technician for help.

This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions:
1)

This device may not cause harmful interference.

2)

This device must accept any interference received, includinginterference that may
cause undesired operation.

Any changes or modifications not expressly approved by the party responsible for compliance
could void the user’s authority to operate the equipment.

FCC RF Radiation Exposure Statement
This equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled
environment. This device and its antenna must not be co-located oroperating in conjunction with
any other antenna or transmitter.
“To comply with FCC RF exposure compliance requirements, this grant is applicable to only
Mobile Configurations. The antennas used for this transmitter must be installed to provide a
separation distance of at least 20 cm from all persons and must not be co-located or operating in
conjunction with any other antenna or transmitter.”CE Mark Warning

This is a class B product. In a domestic environment, this product may cause radio interference, in
which case the user may be required to take adequate measures.

National Restrictions
2400.0-2483.5 MHz
Country

Restriction

Reason/remark
General authorization required for outdoor use and

Bulgaria
public service
Outdoor use limited to 10
mW e.i.r.p. within theband

band has been ongoing in recent years to allow current

2454-2483.5 MHz

France

Military Radiolocation use. Refarming of the 2.4 GHz

relaxed regulation. Full implementation planned 2012
If used outside of own premises, general authorization is

Italy
required
General authorization required for network and service
Luxembourg

None
supply(not for spectrum)
This subsectiondoes not apply for the geographical area

Norway

Implemented
within a radius of 20 km from the centre of Ny-Ålesund

Russian Federation

Note: Please don’t use the product outdoors in France.

Only for indoor applications

TP-LINK TECHNOLOGIES CO., LTD

DECLARATION OF CONFORMITY
For the following equipment:
Product Description: 54M Wireless ADSL2+ Modem Router
Model No.:...