Manual hughes & kettner attax 100

Solo disponible en BuenasTareas
  • Páginas : 103 (25535 palabras )
  • Descarga(s) : 0
  • Publicado : 6 de diciembre de 2011
Leer documento completo
Vista previa del texto
BEDIENUNGSANLEITUNG

ATTAX 100
1 2 0 - WA T T G U I T A R A M P L I F I E R
MODE 2 INPUTS
5 5 0 0 0 5 0 0 0 5 5

FX LOOP

MIDI
5

0

10

0

10

-5

+5

-5

+5

-5

+5

0

10

-5

+5

-5

+5

-5

+5

0

10

0

10

DRY

WET

0

10

LOW

HIGH

CLEAN VOL

CRUNCH

BASS

MID

TREBLE

LEAD GAIN

BASS

MID

TREBLE

LEADMASTER

REVERB

FX MIX

MASTER

MAINS

ESPAÑOL

ITALIANO

M A N UA L

FRANÇAIS

DEUTSCH

STAGE BOARD

CLEAN

CRUNCH

LEAD

MASTER

ENGLISH

IMPORTANT SAFETY INSTRUCTIONS
BEFORE CONNECTING, READ INSTRUCTIONS
• • • • Read all of these instructions! Save these instructions for later use! Follow all warnings and instructions marked on the product! Do not use thisproduct near water, i.e. bathtub, sink, swimming pool, wet basement, etc. • Do not place this product on an unstable cart, stand or table. The product may fall, causing serious damage to the product or to persons! • Slots and openings in the cabinet and the back or bottom are provided for ventilation; to ensure reliable operation of the product and to protect it from overheating, these openings mustnot be blocked or covered. This product should not be placed in a built-in installation unless proper ventilation is provided. • This product should not be placed near a source of heat such as a stove, radiator, or another heat producing amplifier. • Use only the supplied power supply or power cord. If you are not sure of the type of power available, consult your dealer or local power company. •Do not allow anything to rest on the power cord. Do not locate this product where persons will walk on the cord. • Never break off the ground pin on the power supply cord. • Power supply cords should always be handled carefully. Periodically check cords for cuts or sign of stress, especially at the plug and the point where the cord exits the unit. • The power supply cord should be unplugged whenthe unit is to be unused for long periods of time. • If this product is to be mounted in an equipment rack, rear support should be provided. • This product should be used only with a cart or stand that is recommended by Hughes & Kettner. • Never push objects of any kind into this product through cabinet slots as they may touch dangerous voltage points or short out parts that could result in risk offire or electric shock. Never spill liquid of any kind on the product. • Do not attempt to service this product yourself, as opening or removing covers may expose you to dangerous voltage points or other risks. Refer all servicing to qualified service personnel. • Unplug this product from the wall outlet and refer servicing to qualified service personnel under the following conditions: • When thepower cord or plug is damaged or frayed. • If liquid has been spilled into the product. • If the product has been exposed to rain or water. • If the product does not operate normally when the operating instructions are followed. • If the product has been dropped or the cabinet has been damaged. • If the product exhibits a distinct change in performance, indicating a need of service! • Adjust onlythese controls that are covered by the operating instructions since improper adjustment of other controls may result in damage and will often require extensive work by a qualified technician to restore the product to normal operation. • Exposure to extremely high noise levels may cause a permanent hearing loss. • Individuals vary considerably in susceptibility to noise induced hearig loss, butnearly everyone will lose some hearing if exposed to sufficiently intense noise for a sufficient time. The U.S. Government´s Occupational Safety and Health Administration (OSHA) has specified the following permissible noise level exposures:
Duration Per Day In Hours 8 6 4 3 2 11/2 1 1 /2 1 /4 or less Sound LeveldBA, Slow Response 90 92 95 97 100 102 105 110 115

WICHTIGE SICHERHEITSHINWEISE!...
tracking img