Manual Switch 3116P
Quick Installation Guide
0
Content Table
English ..............…………...............……………... 2 Český ................................................................... 5 Deutsch ............................................................... 8 Español .............................................................. 11 Français............................................................. 14 Italiano ............................................................... 17 Magyar ............................................................... 20 Nederlands......................................................... 23 Polski ................................................................. 26 Português.......................................................... 29 Русский.............................................................. 32 Türkçe ................................................................ 35
1
English.
Front Panel & Connectors
Fast Ethernet Switch LED Panel
LED PWR
(Power)
Color Green
Status Lit Off Lit
Description Power is supplied No power A valid link is established Data packets received No link isestablished This port run at 100Mbps This port run at 10Mbps
LNK/ACT
(Link/Activity)
Green
Flash Off
SPEED
(10/100M)
Yellow
Lit Off
2
1. Operating Environment
This switching hub must be installed and operated within the limits of specified operating temperature (32-131°F) and humidity (10~95% Non-condensing). Do not place objects on top of the unit. Do not obstruct anyvents at the sides of the unit. Do not position the unit near any heating source such as heater, radiator, or direct exposure to sun. Prevent entering of water and moisture into the unit. If necessary, use dehumidifier to reduce humidity.
2. Connecting to network devices
The RJ-45 ports on the switch support Auto-MDI/MDI-X function which allows using straight-through or cross-over type cables toconnect this switch to workstation or hub. Connect one end of the network cable to the RJ-45 port on the rear panel, and connect the other end of the network cable to the RJ-45 port on the network device. Follow the same procedure to connect all the RJ-45 ports of the switch. The UTP network cables must comply with EIA/TIA 568 specifications and Category 5 standard for 100Mbps data transmission.Maximum length: using UTP cable, between the switch and connected device is 100 meters (300ft). Once the network cable is connected to both ends and the attached network device is powered on, the green LNK/ACT LED should be lit.
3. Connecting the power
Connect the power adapter to the power connector on the rear panel of the unit; the green Power LED on the front panel should be lit.
3Trouble Shooting
1. Power LED is not lit Check if the power cord is properly connected to the external power adapter and the power outlet. Make sure the DC power jack is firmly plugged into the power socket of the switch. 2. Link/Activity is not lit when connect to 100Mbps device Check the power switch of the network device attached to the switch; make sure it is turned ON. Check the networkcable; make sure it is properly connected to the switch and the network device. Check the network cable; make sure the UTP cables comply with EIA/TIA 568 and Category 5 specification.
[!] Contact your dealer if problem persist.
4
Český.
Čelní panel a konektory
Panel s diodami LED switche pro Fast Ethernet
Dioda LED PWR
(Napájení)
Barva Zelená
Stav Svítí Nesvítí Svítí
PopisZařízení je napájeno Zařízení není napájeno Je vytvořeno platné připojení Jsou přijímány datové pakety Není vytvořeno platné připojení Tento port pracuje s rychlostí 100 Mb/s Tento port pracuje s rychlostí 10 Mb/s
LNK/ACT
(Připojení/Aktivita)
Zelená
Bliká Nesvítí
SPEED
(10/100 M)
Svítí Žlutá Nesvítí
5
1. Provozní prostředí
Tento switch/hub musí být nainstalován a provozován...
Regístrate para leer el documento completo.