Manual Torre Telecomunicación
Installation Manual and Specifications
For 10 m, 20 m, 30 m, 30 m HD, 30 m SHD, 40 m, 40 m HD, 50 m, 50 m HD, 60 m NRG TallTowers™
110 Riggs Road ● Hinesburg VT 05461 USA ● TEL 802.482.2255 ● FAX 802.482.2272 ● email sales@nrgsystems.com ● www.nrgsystems.com
TallTowerManual-7.11.doc 15 February 2007
© NRG Systems, Inc. PO Box 509 Hinesburg VT 05461 USA Tel:802-482-2255 Fax: 802-482-2272 sales@nrgsystems.com www.nrgsystems.com
Specifications are subject to change without notice.
TallTowerManual-7.11.doc
1
15 February 2007
Installation of guyed towers is inherently dangerous. To minimize risks, read and follow the tower installation instructions explicitly. Installation in agricultural areas may pose a threat to low flying crop dusting aircraft.Notify appropriate parties and install warning devices as needed. NRG Systems, Inc. assumes no responsibility or liability in connection with any act, error, omission, or for any injury, loss, accident, delay, inconvenience, irregularity or damage related to any TallTower installation.
DANGER: YOU CAN BE
KILLED
IF THIS TOWER COMES NEAR ELECTRIC POWER LINES FOR YOUR SAFETY, FOLLOW THESEINSTALLATION INSTRUCTIONS.
TallTowerManual-7.11.doc
2
15 February 2007
Table of Contents
Note that page numbers correspond to the printed version of this manual; these may differ slightly in the pdf version of the manual.
Table of Contents........................................................................................................................................ 3 WARNINGS.................................................................................................................................................. 5 Typical Wind Monitoring Site..................................................................................................................... 6 Description.................................................................................................................................................. 7 Tools Required............................................................................................................................................ 7 Installation of Anchors and Base Plate .................................................................................................... 7
Figure 1: Tower Site Layout.................................................................................................................................................9 Table 1: Tower and Anchor Layout Dimensions ..................................................................................................................9 Figure 2: Winch AnchorPlacement....................................................................................................................................10 Figure 3: TallTower Base Plate Assembly (for 3.5 inch dia. towers) ..................................................................................11 Figure 4: TallTower Base Plate Assembly (for 4.5 inch dia. towers) ..................................................................................12 Figure 5: TallTower Base PlateAssembly (for 6 inch and 8 inch dia. towers) ...................................................................13 Figure 6: 10 m TallTower Assembly...................................................................................................................................15 Figure 7: 20 m TallTowerAssembly...................................................................................................................................16 Figure 8: 30 m TallTower Assembly...................................................................................................................................17 Figure 9: 30 m HD TallTower Assembly ............................................................................................................................18 Figure 10: 30 m SHD...
Regístrate para leer el documento completo.