Suplemento Kia

Engine idle hang up during gear changes
Model: Ka built from 09.1996 to 09.2001 with 1.3L Endura-E engine Summary: Should a customer express concern about engine idle hang up during gear changes,the probable cause is a corrupt throttle position sensor (TPS) signal due to poor electrical contact at the electrical connector. This concern should be rectified by installing a new TPS wiring loom andconnector.
TIZ0012180

Parts Required Description TPS connector and wire assembly Heat shrink sleeving (as required) Insulation tape (as required) Removal Finis 1 150 138 Locally Procured LocallyProcured

6. Remove and discard the old TPS connector • Using a sharp knife, cut the three wires • Insulate the ends using suitable tape • Install wires back into protective sheath InstallationZ0112180

TIZ0012175

7. Install new wiring loom TPS connector (see Parts Required)
• • • • • Trim 6mm of insulation from each wire Install heat shrink sleeving (see Parts Required) to each wireSolder each joint (3 per wire) Position heat shrink sleeving over each joint and apply heat using a hot air gun with suitable nozzle adaptor Bind the joints with insulating tape (see Parts Required)1. Disconnect the battery ground cable 2. Disconnect the TPS electrical connector

Z0112182

3. Remove TPS wires from wiring protection
Note: Use a pin to gain access for the multimeter on theengine wiring loom. Note: Mark each correctly identified wire with suitable tape

FordKa - Electrical Your Technical Supplement 13
Z0112181

Z0112179

8. Install wires into wiring protection •Tape wiring protection so that no wires are exposed

FordParts

4. Carry out a continuity check, to locate the correct wires, between the TPS connector (C114) pins and the engine wiring loom, usingthe following as a guideline: • Pin 1 (BK) to yellow wire • Pin 2 (BK) to white wire (2 in the loom) • Pin 3 (BN) to brown red wire (2 in the loom) 5. Using a sharp knife, cut the three engine...