Tecnico

Series 962
Electronic Stager Control

Operation Manual

TIME OF DAY TIME OF REGEN HARDNESS FLOW PM SERIES 962 CAPACITY REGEN TIME REMAINING

SET

REGEN

2

Table of Contents
Declaration of Conformity . . . . . . . . . . . . . . . . 3 Caution and Warning Symbols . . . . . . . . . . . . 4 Series 962 Electronic Stager Controls . . . . . . . 6 Special Features of the Series 962Stagers. . . 6
Memory Retention Programmable Cycles Double Regeneration Capacity Setting Lockout Selectable Reserve Options U.S. or Metric Units of Measure Calendar Override Manual Regeneration Operating Histories Remote Regeneration Selectable Automatic Regeneration Optional Battery Backup Flow Rate Display

Programming the Series 962 Stager . . . . . . . . 7
Factory Default Values Program LevelsLevel I Programming Setting Time of Day Level II Programming Changing a Program Value Level III Programming Level IV Programming Entering “C” Values Entering “d” Values Viewing a Program Value Manual Regeneration Lock-out Feature

Flow Sensor Select Options . . . . . . . . . . . . . . 9 Capacity Based Regeneration Start Options . . 9
Immediate Regeneration Only Option Installation ProgrammedValues Chart

Advance Cycle Function . . . . . . . . . . . . . . . . . 7 Cancel Regeneration Function . . . . . . . . . . . . 7 Parallel Operation . . . . . . . . . . . . . . . . . . . . . 15 Twin Alternating Operation . . . . . . . . . . . . . . 15 Flow Sensor Connections . . . . . . . . . . . . . . . 16 AC Power Wiring . . . . . . . . . . . . . . . . . . . . . . 16 Remote Regeneration . . . . . .. . . . . . . . . . . . 17 Relay Output Option . . . . . . . . . . . . . . . . . . . 17

3

Caution and Warning Symbols
The following international symbols appear in this manual to highlight caution and warning messages. circuit breaker must be in close proximity to this equipment and in easy reach of the operator. It must be clearly marked to indicate that it is the disconnecting devicefor this equipment. Recommend fuse size is 1 AMP. Voltage Range: 230/115VAC (+/- 10%) Frequency Range: 50/60Hz Max. Rated Power: 4 Watts Pollution Degree: 2

Cautions
Not heeding these messages could result in personal injury and/or damage to equipment. Caution: This symbol indicates caution messages (Refer to User Manual).

Warnings
Not heeding these messages could result in serious personalinjury. Warning: This symbol is intended to alert the user to the presence of “dangerous voltage” within the product’s enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons.

Overvoltage Category: II Altitude: 6500 Ft. (2000 Meters) Max. Rated Fluid (Air/Water) Pressures

Model E948 125 psi (8.6 bar)

Model E951 125 psi (8.6 bar)

Model E958/ E959125 psi (8.6 bar)

Specifications
Warning: Class I equipment - The composite enclosure used in this equipment does not automatically provide grounding between conduit connections. Use grounding bushing and jumper wires as part of the installation. To avoid electric shock, grounding must be installed by the customer as part of the installation. Installation should be completed by qualifiedelectricians and in accordance with the requirements of all state and local electrical codes as well as the National Electrical Code (NEC). A separate ground post has been provided inside this equipment enclosure and is indicated by the NEC ground symbol as shown below.

NEMA 4X Enclosure: Intended for indoor or outdoor use primarily to provide a degree of protection against corrosion, windblown dustand rain, splashing water; undamaged by the formation of ice on the enclosure. The enclosure door must be kept tightly closed using all fasteners provided. Any modifications to this enclosure (i.e., added holes for cable entry/ mounting, conduit connections...etc.) may void the intended NEMA 4X rating. NEMA 4 and UL rated fittings should be used when modifying the enclosure.

Relative...