1.2 M compact antenna installation instruction

1.2 m Compact Antenna
Installation Instruction

MINI-LINK

TM

1.2 m Compact Antenna
Installation Instruction

Copyright © Ericsson AB 2006 - All rights reserved. No parts of this publication may be reproduced, stored in a retrieval system, or transmitted in any form or by any means, electronic, mechanical, photocopying, recording or otherwise, without prior permission of thepublisher. Disclaimer The contents of this document are subject to revision without notice due to continued progress in methodology, design, and manufacturing. Ericsson shall have no liability for any error or damage of any kind resulting from the use of this document.

1/1531-COH 901 090/1 Uen H 2006-08-30

Contents

Contents
1 1.1 1.2 1.3 2 2.1 2.2 2.3 2.4 2.5 3 3.1 3.2 4 4.1 4.2 4.3 4.4 5 5.15.2 6 7 7.1 7.2 8 8.1 9 9.1 Introduction Target Group Revision Information Related Documents Safety Instructions Introduction Standards Safety Requirements Safety Symbols and Definitions Hazards Equipment and Tools Tools Equipment Assembly Procedure Preparations Assembling Radome and Shield Panels Assembling the Antenna Mount Fitting the Feeder Installation Procedure Fitting the Antenna Fittingthe Radio Unit Radio Cable Installation Antenna Alignment and Software Setup Alignment Procedure Software Setup Tightening Procedure Side Strut Installation Repair Handling Shipping Instructions 1 2 2 2 3 3 3 5 6 7 11 11 12 15 15 18 22 27 33 33 38 41 43 43 46 47 49 51 51

1/1531-COH 901 090/1 Uen H 2006-08-30

1.2 m Compact Antenna

1/1531-COH 901 090/1 Uen H 2006-08-30

Introduction

1Introduction
This instruction describes how to assemble and install a 1.2 m compact antenna (4 ft). The instruction applies to the RAU1 and RAU2 radio units. Only the installation procedure for RAU2 is described, since the installation procedure for RAU1 is similar.

RADIO CABLE

ALARM

POWER

ALIGNMENT

9003

Figure 1

1.2 m Compact Antenna (4 ft)

In general, a right-sideinstallation is described, though it is possible to choose a left-side installation as well.

1/1531-COH 901 090/1 Uen H 2006-08-30

1

1.2 m Compact Antenna

1.1

Target Group
This manual is targeted at the personnel (installation technicians) who work with the installation of MINI-LINK equipment on site. The personnel must be authorized and have appropriate technical training andexperience. The personnel is expected to be experienced in radio and mobile communications and have basic understanding of technical English or any other language in which this manual is available.

1.2

Revision Information
The following changes have been made since the last release: • • The installation instructions in section 4.4 “Fitting the Feeder” have been updated to include the AXR 7-13 GHzfeeders. The illustrations in section 4.4 “Fitting the Feeder” have been updated to include the AXR 7-13 GHz feeders.

1.3

Related Documents
The following documents contain information related to the 1.2 m compact antenna. These documents are referred to using document names only. Note: Table 1 Product numbers starting with EN/LZT are in A4 size and product numbers starting with AE/LZT arein Letter size. Related Documents
EN/LZT 712 0015 AE/LZT 712 0015

MINI-LINK TN, MINI-LINK HC, MINI-LINK E Outdoor Installation Manual

2

1/1531-COH 901 090/1 Uen H 2006-08-30

Safety Instructions

2
2.1

Safety Instructions
Introduction
This section describes the system used for presenting safety information. Note: Reduce the risk of accidents by studying all the instructionscarefully before you start working. Should questions arise regarding the safety instructions, contact your supervisor or your local Ericsson representative.

The relevant manual (including this safety information) and specific instructions supplied by Ericsson must be followed in any work performed on Ericsson products or systems. Sufficient knowledge of English or of any other language, in...