3Com

Table of Contents
1 CLI Configuration Commands··················································································································1-1 CLI Configuration Commands·················································································································1-1 command-privilegelevel··················································································································1-1 display history-command·················································································································1-3 super················································································································································1-4 superauthentication-mode··············································································································1-5 super password ·······························································································································1-6

i

1
Syntax

CLI Configuration Commands

CLI Configuration Commands
command-privilege level

command-privilege level level view view command undo command-privilege view view command View System view Parameters level level: Command level to be set, in the range of 0 to 3. view view: CLI view. It can be any CLI view that theEthernet switch supports. The 3com switch 4500 supports only the CLI views listed in Table 1-1: Table 1-1 Available CLI views for the view argument CLI view acl-adv acl-basic acl-ethernetframe acl-user aux cluster detect-group ethernet ftp-client gigabitethernet hwtacacs isp loopback luser manage-vlan mst-region null Description Advanced ACL view Basic ACL view Layer 2 ACL view User-defined ACL viewAux 1/0/0 port view, that is, console port view Cluster view Detected group view 100M Ethernet port view FTP client view GigabitEthernet port view HWTACACS view ISP domain view Loopback interface view Local user view Management VLAN view MST region view NULL interface view

1-1

CLI view peer-key-code peer-public-key poe-profile qinq qos-profile radius-template remote-ping rip route-policyshell system user-interface vlan vlan-interface

Description Public key editing view Public key view PoE profile view QinQ view QoS profile view RADIUS scheme view Remote-ping test group view RIP view Routing policy view User view System view User interface view VLAN view VLAN interface view

command: Command for which the level is to be set. Description Use the command-privilege level command toset the level of a specified command in a specified view. Use the undo command-privilege view command to restore the default. Commands fall into four levels: visit (level 0), monitor (level 1), system (level 2), and manage (level 3). The administrator can change the level of a command as required. For example, the administrator can change a command from a higher level to a lower level so that thelower level users can use the command. The default levels of commands are described in the following table: Table 1-2 Default levels of commands Level 0 Name Visit level Command Commands used to diagnose network, such as ping, tracert, and telnet commands. Commands used to maintain the system and diagnose service fault, such as debugging, terminal and reset commands. All configuration commandsexcept for those at the manage level. Commands associated with the basic operation modules and support modules of the system, such as file system, FTP/TFTP/XMODEM downloading, user management, and level setting commands.

1

Monitor level

2

System level

3

Manage level

1-2

Note that: You are recommended to use the default command level or modify the command level under theguidance of professional staff; otherwise, the change of command level may bring inconvenience to your maintenance and operation, or even potential security problem. When you change the level of a command with multiple keywords or...