Analizador En Linea

On Belt Analyser

Installation Manual

Version 15

Scantech International Pty Ltd ABN 56 087 557 426 143 Mooringe Avenue Camden Park SA 5038 AUSTRALIA Tel: +61 8 8350 0200 Fax: +61 8 8350 0188

Terms used in this specification which are known or suspected to be trademarks are listed below. Use of a term in this specification should not, however, be regarded as affecting the validity ofany trademark or service mark.
superSCAN is a trademark of Scantech International Pty Ltd Microsoft and Windows are trademarks of Microsoft Corporation iFIX™ is a trademark of Intellution Incorporated

This document must not be reproduced in any form without the written consent of Scantech International Pty Ltd.

MA0003R15 On Belt Analyser Installation.doc2 of 35

Contents

CONTENTS........................................................................................................ 3 ABOUT THIS MANUAL ...................................................................................... 7
Contents of this Manual ................................................................................................................... 7 Conventions................................................................................................................................... 7

INTRODUCTION ................................................................................................ 8
Introducing the On Belt Analyser.................................................................................................... 8Description........................................................................................................................................ 9 Operating Principle .........................................................................................................................10 Data Display ....................................................................................................................................10 OptionalsuperSCAN (supplied by Scantech).................................................................................10 Optional Plant Interface (supplied by the client) ............................................................................10

RECEIPT AND STORAGE REQUIREMENTS ................................................. 11
Receiving the Shipment...................................................................................................................11 Storage Requirements .....................................................................................................................11 Storing the Calibration Standards .................................................................................................11 Storing the RadioactiveSource......................................................................................................12

SITE REQUIREMENTS .................................................................................... 13
Location Requirements ...................................................................................................................13 InputsRequired.............................................................................................................................13 Outputs .........................................................................................................................................14 Engineering Requirements..............................................................................................................14 On Belt Analyser Dimensions.......................................................................................................14 Approximate Installed Mass ..........................................................................................................15 Clearances Required .....................................................................................................................16 Lifting Equipment...