Ap maxnet

Power

System

LAN

WLAN

108M
SkyNet

Wireless Access Point

WA7500-SG

COPYRIGHT & TRADEMARKS
Specifications are subject to change without notice Maxnet. is a registered trademark of Other brands and product names are trademarks or registered trademarks of their respective No part of the specifications may be reproduced in any form or by any means or used to make anyderivative such as translation, transformation, or adaptation without permission from MAXNET. All rights reserved. http://www.maxnet.pe

FCC STATEMENT

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to pro-vide reasonable protection against harmful interference in a residentialinstallation. This equipment generates, uses and can radiate radio frequency energy and, if not in-stalled and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, whichcan be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: • • • • Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer oran experienced radio/ TV technician for help. e

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: 1) 2) This device may not cause harmful interference. This device must accept any interference received, including interference that may cause undesired operation.

Any changes or modifications not expressly approved by the partyresponsible for compliance could void the user’s authority to operate the equipment.

FCC RF Radiation Exposure Statement
To comply with FCC RF exposure compliance requir ements, this grant is applicable to only Mobile Configurations. The antennas used for this transmitter must be installed to provide a separation distance of at least 20 cm from all persons and must not be co-located oroperating in conjunction with any other antenna or transmitter.

CE Mark Warning

This is a class B product. In a domestic environment, this product may cause radio interference, in which case the user may be required to take adequate measures.

National Restrictions 2400.0-2483.5 MHz Country
Bulgaria Outdoor use limited to 10 mW e.i.r.p. within the band 2454-2483.5 MHz

RestrictionReason/remark
General authorization required for outdoor use and public service Military Radiolocation use. Refarming of the 2.4 GHz band has been ongoing in recent years to allow current relaxed regulation. Full implementation planned 2012 If used outside of own premises, general authorization is required

France

Italy

Luxembourg

None

General authorization required for networkand service supply(not for spectrum) This subsection does not apply for the geographical area within a radius of 20 km from the centre of Ny-Ålesund Only for indoor applications

Norway Russian Federation

Implemented

Note: Please don’t use the product outdoors in France.

CONTENTS
Package Contents.................................................................................................... 1 Chapter 1 Introduction ........................................................................................... 2
1.1 Product Overview .............................................................................................. 2 1.2 Main Features ................................................................................................... 2 1.3 Conventions...