Car Seat

® Convertible Car Seat

Harness Strap Replacement Instructions
Do not use this car seat until you read and understand these instructions! Incorrect usage can mean serious injuryor death to a child in a sudden stop or accident!
If you need help, please call 1-800-837-4044

b Remove Current Harness Straps:

b Install New Harness Straps:
Harness Straps1 Loosen harness straps:
• Lift Adjuster Lever on lower front of car seat. • Pull harness straps. Adjuster Lever

1 With both harness straps towards car seat
and short straptowards you: • Insert anchor into slot in bottom of shield exactly as shown. • Pull harness strap to check that anchor does not come out.

Anchor Slot

Harness Straps

2 Removeharness strap loops
from Splitter Plate. Loops

2 Buckle latch tongue into opening.

Splitter Plate

3 Thread right harness strap through 3 Pull harness straps out of currentslots.
right side of harness tie (child's right).

4 Remove harness tie from harness
straps.

4 Thread harness straps through desired
slots of seat pad and car seat shell.IMPORTANT: • For rear-facing infants, bottom or middle slots, which are at or just below shoulders, must be used. • For forward-facing toddlers, top slots must be used.

5 Push redbutton on lower front
of car seat to unbuckle latch tongue.

5 Slide loop on end of each harness
strap onto Splitter Plate.

Red Button

6 Cut harness strap close to shield.NOTE: Do not attempt to remove metal anchor inside shield. Loose metal anchor may remain inside shield. Throw harness strap away. Cut Here Close To Shield

Shield

6 Make sureSplitter Plate Strap
passes between recliner stand and car seat shell (see arrow). NOTE: Splitter Plate Strap must not be twisted. Splitter Plate Strap
ENGLISH PM-0548AA 4/97