Ciencia

INSTRUCTION MANUAL

KEB COMBIVERT S4

Size D / E

03.S4.0EB-K100

POWER TRANSMISSION

11/98

This manual – is valid for the frequency inverter KEBCO COMBIVERT S4 Servo Amplifier – Part number xx.S4.DxE-xxxx or xx.S4.ExE-xxx – must be made available to all users Before working with this unit you must familiarize yourself with it.

Pay special attention to the safety and warningguides. Make sure to read the entire instruction manual before starting the unit!

The KEBCO COMBIVERT S4 has very extensive programming capabilities. To make the operation and start-up simpler for the user, a special operator level was created in which the most important parameters are found. However, if these basic parameters are not sufficient for your application an application and referencemanual are available for in depth programming. Consult KEBCO for more information.

The icons used in this manual are defined as follows:

Danger Warning Caution

Used when the life or health of the user is at risk or when considerable damage to property can occur.

Attention

Must be observed! Special instructions for safe and trouble-free operation.

Information

Helpful hint.Programming tip.

Table of Contents
ANTRIEBSTECHNIK

1. 1.1 1.2 1.3

Introduction KEB COMBIDYN S4 ..................................... E 4 Part Code ...................................................... E 4 Application ..................................................... E 4

8.

Parameter Description .............................. E 28

2. 2.1 2.2 2.3 2.4 2.5 2.6

OperatingSpecifications Moving or Rotating Parts ............................... E 5 High Operating Temperatures ....................... E 5 Connection Directions ................................... E 5 Interference Protection of Servo Controller ... E 6 Interference Protection of Electrical Plants ... E 6 Operating Directions ..................................... E 6

9. 9.1 9.2 9.3 9.4 9.5 9.6

Drive ModeSetting Possibilities ..................................... E 37 Condition ..................................................... E 37 Display and Keyboard ................................. E 37 Setpoint Display / Setpoint Presetting ......... E 37 Rotation Presetting ...................................... E 38 Start / Stop / Run ......................................... E 38

3. 3.1 3.2 3.3 3.4 3.5Control Cabinet Installation Ambient Conditions ....................................... E 7 Type of Protection ......................................... E 7 Installation Instructions ................................. E 7 Calculations .................................................. E 8 Installation Conditions ................................... E 8

10. 10.1 10.1.1 10.1.2 10.1.3 10.1.4 10.210.2.1 10.2.2 10.2.3 10.3 10.3.1 10.4

Accessories Braking Resistor .......................................... E 39 Part Number ................................................ E 39 Technical Data ............................................ E 39 Dimensions ................................................. E 39 Connection .................................................. E 39 RadioInterference Suppression Filter ......... E 40 Technical Data ............................................ E 40 Connection .................................................. E 40 Dimensions ................................................. E 40 Braking Motor .............................................. E 41 Technical Data ............................................ E 41 Operator...................................................... E 42

4. 4.1 4.2 4.3 4.4

Technical Data Technical Data 230 V Class .......................... E 9 Technical Data 400 V Class ........................ E 10 Torque-Speed Characteristics .................... E 12 Technical Data 230 V / 400 V Class ........... E 16

5. 5.1 5.2

Dimensions Dimensions Servo Controller ...................... E 17 Dimensions Servo...