Cisco

Close Window

Assessment System

Exam Viewer - ESwitching Final Exam - CCNA Exploration (Version 4.0)

Below you will find the assessment items as presented on the exam as well as the scoring rules associated with the item. Use of the exam information in the Exam Viewer is subject to the terms of the Academy Connection Website Usage Agreement between you and Cisco. The purpose of the ExamViewer is to support instruction while not compromising exam security for other Cisco Networking Academies or students. This material should not be distributed outside a proctored and controlled setting. If misuse is found, action will be taken to limit access to assessment content. Please remember to logout and close your browser window after using the Exam Viewer. 1

Refer to the exhibit. Whatwill allow a host on VLAN 40 on switch X to communicate with a host in VLAN 40 on switch Y? QoS routing trunking VPN

Scoring Rule For: correctness of response 2 points for Option 3 0 points for any other option

Max Value = 2 This item references content from the following areas: CCNA Exploration 3.2.1 VLAN Trunks 2

Refer to the exhibit. Each switch is shown with its MAC address. Whichswitch will be elected as the spanning-tree root bridge if the switches are configured with their default priority values? switch A switch B switch C switch D switch E switch F

Scoring Rule For: correctness of response 2 points for Option 6 0 points for any other option Max Value = 2 This item references content from the following areas: CCNA Exploration 5.2.3 Bridge ID 3

Refer to theexhibit. The network administrator enters the configuration shown to allow both SSH and Telnet connections to the switch. The Telnet connections fail. What is the most likely cause of this problem? The SSH version number is wrong. SSH has been configured on the wrong line. Telnet and SSH cannot be configured simultaneously. The transport input command is configured incorrectly.

Scoring Rule For:correctness of response 2 points for Option 4 0 points for any other option Max Value = 2 This item references content from the following areas: CCNA Exploration 2.4.3 Configure Telnet and SSH 4

Refer to the exhibit. Which two statements are true regarding what the cost value of 23 represents for Switch4? (Choose two.) This cost represents the lowest cost path for Switch4 to the root switch. A costof 23 is the value being advertised out port 16 on the switch upstream (closer) to the root switch. Switch4 adds the cost of a Fast Ethernet link to 23 to determine its total cost to reach the root switch. Switch4 is connected via a Fast Ethernet link to an upstream switch that in turn is directly connected to the root switch via a Gigabit Ethernet link.

The root switch is advertising a costof 23, which is lower than any other switch in the VLAN0001 spanning-tree domain. Scoring Rule For: correctness of response Option 1 and Option 4 are correct. 1 point for each correct option. 0 points if more options are selected than required. Max Value = 2 This item references content from the following areas: CCNA Exploration 5.2.1 The Spanning Tree Algorithm 5 Why is it important that thenetwork administrator consider the spanning-tree network diameter when choosing the root bridge? The network diameter limitation is 9. BPDUs may be discarded because of expiring timers. The cabling distance between the switches is 100 meters. The network diameter must be set to the number of meters of the cable between the root bridge and its farthest connected switch. Scoring Rule For: correctness ofresponse 2 points for Option 2 0 points for any other option Max Value = 2 This item references content from the following areas: CCNA Exploration 5.2.5 STP Port States and BPDU Timers 6 Which three statements are true regarding router-on-a-stick interVLAN routing? (Choose three.) requires the use of subinterfaces on the router requires an access link between the router and Layer 2 switch more...