Diagrama ps2 series 39001

SCPH-39001

SCPH-39000 series
SERVICE MANUAL
for GH017 MOUNT (G-chassis)
1st Edition

CS Department
Published in Japan 4. 2002. 9-927-094-11

Reproduction Prohibited
NOTICE
Copyright by Sony Computer Entertainment Inc. All rights reserved. No reproduced and transferred required except permission by Sony Computer Entertainment Inc. No commercial use and rental required.

SCPH-39001G-chassis
ADVARSEL
Eksplosjonsfare ved feilaktig skifte av batteri. Benytt samme batteritype eller en tilsvarende type anbefalt av apparatfabrikanten. Brukte batterier kasseres i henhold til fabrikantens instruksjoner.

REVISIONS.
This manual compiled by first edition of SCPH-39000 series design data. Design and Specification will be subject to changed without notice. The latest versions ofservice manual, Technical memo, Technical information should be used together.

VARNING
Explosionsfara vid felaktigt batteribyte. Använt samma batterityp eller en ekvivalent typ som rekommenderas av apparattillverkaren. Kassera använt batteri enligt fabrikantens instruktion.

SAFETY-RELATED COMPONENT WARNING !!
COMPONENTS IDENTIFIED BY MARK OR DOTTED LINE WITH MARK ON THE SCHEMATIC DIAGRAMSAND IN THE PARTS LIST ARE CRITICAL TO SAFE OPERATION. REPLACE THESE COMPONENTS WITH SONY PARTS WHOSE PART NUMBERS APPEAR AS SHOWN IN THIS MANUAL OR IN SUPPLEMENTS PUBLISHED BY SONY.

VAROITUS
Paristo voi räjähtää, jos se on virheellisesti asennettu. Vaihda paristo ainoastaan valmistajan suosittelemaan tyyppiin. Hävitä käytetty paristo valmistajan ohjeiden mukaisesti.

SAFETY CHECK-OUT
Aftercorrecting the original service problem, perform the following safety checks before releasing the set to the customer: 1. Check the area of your repair for unsoldered or cold-soldered connections. Check the entire board surface for solder splashes and bridges. 2. Check the inter board wiring to ensure that no wires are “pinched” or contact high-wattage resistors. 3. Look for unauthorizedreplacement parts, particularly transistors, that were installed during a previous repair. Point them out to the customer and recommend their replacement. 4. Look for parts which, though functioning, show obvious signs of deterioration. Point them out of the customer and recommend their replacement. 5. Check the line cord for cracks and abrasion. Recommend the replacement of any such line cord to thecustomer. 6. Check the b+ voltage to see it is at the values specified. 7. Check the antenna terminals, metal trim, “metalized” knobs, screws, and all other exposed metal parts for ac leakage. Check leakage as described below.

ATTENTION AU COMPOSANT AYANT RAPPORT À LA SÉCURITÉ !
LES COMPOSANTS IDENTIFIÉS PAR UNE MARQUE SUR LES DIAGRAMMES SCHÉMATIQUES ET LA LISTE DES PIÈCES SONT CRITIQUES POUR LASÈCURITÈ DE FONCTIONNEMENT. NE REMPLACER CES COMPOSANTS QUE PAR DES PIÈCES SONY DONT LES NUMÉROS SONT DONNÉS DANS CE MANUEL OU DANS LES SUPPLÉMENTS UBLIÉS PAR SONY.

CAUTION
Replace the battery with a Sony CR2032 battery. Use of any other type of battery may present the risk of fire or explosion. The battery may explode if mistreated. Do not recharge, disassemble, or dispose of in fire.

CAUTIONThe use of optical instruments with this product will increase eye Hazard. As the laser beam used in this CD/DVD player is harmful To eyes, do not attempt to disassemble the cabinet. Refer servicing to qualified personnel only.

LEAKAGE
The AC leakage from any exposed metal part to earth ground and from all exposed metal parts to any exposed metal part having a Return to chassis, must notexceed 0.5 mA (500 micro-ampers). Leakage current can be measured by any one of three methods. 1. A commercial leakage tester, such as the SIMPSON 229 or RCA WT-540A. Follow the manufacturers’ instructions to use these instruments. 2. A battery-operated AC milli-ammeter. The Data Precision 245 digital multi-meter is suitable for this job. 3. Measuring the voltage drop across a resistor by means of...