Drgfd

Radio signals are a form of electromagnetic wave, and as they are the way in which radio signals travel, they have a major bearing on RF antennas themselves and RF antenna design.
Electromagnetic waves are the same type of radiation as light, ultra-violet and infra red rays, differing from them in their wavelength and frequency. Electromagnetic waves have both electric and magnetic componentsthat are inseparable. The planes of these fields are at right angles to one another and to the direction of motion of the wave.

An electromagnetic wave
The electric field results from the voltage changes occurring in the RF antenna which is radiating the signal, and the magnetic changes result from the current flow. It is also found that the lines of force in the electric field run along thesame axis as the RF antenna, but spreading out as they move away from it. This electric field is measured in terms of the change of potential over a given distance, e.g. volts per metre, and this is known as the field strength. Similarly when an RF antenna receives a signal the magnetic changes cause a current flow, and the electric field changes cause the voltage changes on the antenna.
There are anumber of properties of a wave. The first is its wavelength. This is the distance between a point on one wave to the identical point on the next. One of the most obvious points to choose is the peak as this can be easily identified although any point is acceptable.

Wavelength of an electromagnetic wave

The wavelength of an electromagnetic wave
The second property of the electromagneticwave is its frequency. This is the number of times a particular point on the wave moves up and down in a given time (normally a second). The unit of frequency is the Hertz and it is equal to one cycle per second. This unit is named after the German scientist who discovered radio waves. The frequencies used in radio are usually very high. Accordingly the prefixes kilo, Mega, and Giga are often seen. 1kHz is 1000 Hz, 1 MHz is a million Hertz, and 1 GHz is a thousand million Hertz i.e. 1000 MHz. Originally the unit of frequency was not given a name and cycles per second (c/s) were used. Some older books may show these units together with their prefixes: kc/s; Mc/s etc. for higher frequencies.
The third major property of the wave is its velocity. Radio waves travel at the same speed as light.For most practical purposes the speed is taken to be 300 000 000 metres per second although a more exact value is 299 792 500 metres per second.

Frequency to Wavelength Conversion
Although wavelength was used as a measure for signals, frequencies are used exclusively today. It is very easy to relate the frequency and wavelength as they are linked by the speed of light as shown:
lambda = c / fwhere lambda = the wavelength in metres
f = frequency in Hertz
c = speed of radio waves (light) taken as 300 000 000 metres per second for all practical purposes.
Field measurements
It is also interesting to note that close to the RF antenna there is also an inductive field the same as that in a transformer. This is not part of the electromagnetic wave, but it can distort measurements closeto the antenna. It can also mean that transmitting antennas are more likely to cause interference when they are close to other antennas or wiring that might have the signal induced into it. For receiving antennas they are more susceptible to interference if they are close to house wiring and the like. Fortunately this inductive field falls away fairly rapidly and it is barely detectable atdistances beyond about two or three wavelengths from the RF antenna.

Electronic capacitors are one of the most widely used forms of electronics components. However there are many different types of capacitor including electrolytic, ceramic, tantalum, plastic, sliver mica, and many more. Each capacitor type has its own advantages and disadvantages can be used in different applications.
The choice of...