Drivers bam

CONTENTS

1. Introduction
2. Automatic Setup
3. Uninstalling

1. Introduction

This article describes how to install and uninstall USBDriver for PST. You must be able to setup the USB driver, before you execute the PST program for the first time.

2. Automatic Setup

1. Shows the Device manager inWindows. This is the initial stage.

[pic]
[ Picture 2.1 ] Device Manager

2. Execute < highland-V4_38_5_261-customer-free_WHQLed.zip/Setup.exe> file supported byPANTECH&CURITEL.
Then click install button.

[pic]
[ Picture 2.2 ]

3. If software was installed successfully, you will be able to see the message box[refer to picture 2.4.]

[pic]
[ Picture 2.4 ]

4. We need to confirm before the PST program starts.
And connect your device. Check the Device Managerthat is composed of Modems, Ports (Com&LPT), and the Universal Serial Bus Controllers.
If you verify the tree device in device manager, the job is successful.[pic]
[ Picture 2.5 ]

5. Take notice of each device’s property.
PST Program uses Curitel Packet Service Port in Modems. In the example Windows, CuritelPacket Service Port was composed with COM5.

[pic]
[Picture 2. 6]

3. Uninstalling

1. Close PST if it is running.
2. Before uninstalling, you have toeject your device from laptop.
3. Remove the USB Driver. This can be done by removing your device from the Add or Remove Programs in the Windows Control Panel.
4.Restart your laptop.

-----------------------

USB Driver Manual

Issued: JAN., 2007
Copyright ( 2007 PANTECH&CURITEL COMMUNICATIONS, INC.
All rights reserved