Dualstage

Real Performance Product by Gizzmo

Thank you for purchasing the Gizzmo Dual Stage Shift Light. This manual contains operating instructions and installation procedures that are needed for the fitting and operation of this product.

Instruction Manual

www.gizzmoelectronics.com

Gizzmo Electronics Ltd Warranties Statement
Gizzmo Electronics Limited Limited Warranties Statement Effective1 January 2003 All products manufactured or distributed by Gizzmo Electronics are subject to the following Limited Express Warranties, and no others: For a period of one year from and after the date of purchase of a new Gizzmo Electronics product, Gizzmo Electronics warranties and guarantees only to the original purchaser/user that such a product will be free from defects of material andworkmanship in the manufacturing process. A product claimed to be defective must be returned to place of purchase. Gizzmo Electronics, at its sole option, shall replace the defective product with a comparable new product or repair the defective product. This express warranty shall be inapplicable to any product not properly installed and properly used by the purchaser/user or to any product damaged orimpaired be external forces. This is the extent of Warranties available on this product. Gizzmo Electronics shall have no liability whatsoever for consequential damages following from the use of any defective product or by reason the failure of any product. Gizzmo Electronics specifically disclaims and disavows all other warranties, express or implied including, without limitation, all Warranties offitness for a particular purpose, Warranties of Description, Warranties of Merchantability, Trade Usage or Warranties of Trade Usage. The above warranty is valid to New Zealand only as Gizzmo Electronics does not offer an international warranty.

2

Gizzmo Dual Stage Shiftlight
Warnings:
Incorrect installation can harm or damage the product. Gizzmo Electronics will not warranty any item thathas been damaged due to incorrect installation, or misuse of product. Never disassemble, modify, or tamper with unit. Failure may cause injury or fire, and void warranty.

Operating Instructions
Shift Set (rear button)
The shift set button sets the rpm at which the shiftlight will illuminate. At this point the outer ring of red LED’s will illuminate. Usually this is the point that the gearshould be changed. The shift or red LED’s should have the higher setting of the two lights. To set the shiftlight: 1. Start the vehicle 2. While out of gear bring the rpm to half the desired gear change rpm. Eg. If changing at 6000rpm bring revs up to 3000rpm 3. Press the rear shift set button, the red LED’s will flash when set 4. The shift lamp is now set.
3

Shift Set Button Pre Shift SetButton

Pre-shift Set (front button)
The pre-shift set button sets the rpm at which the pre-shift light will illuminate. At this point the center yellow LED will illuminate. This point is where you would usually get ready to change gear. The pre-shift or yellow LED should be set lower than the shift point. To set the pre-shiftlight: 1. Start the vehicle 2. While out of gear bring the rpm to halfthe desired preshift rpm. eg. If pre-shift at 5800rpm bring revs up to 2900rpm 3. Press the front pre-shift set button, the center yellow LED will flash when set. 4. The pre-shiftlight is now set.

4

Installation Instructions

RED WIRE BLUE WIRE -

Positive 12v computer terminal Negative computer terminal

YELLOW/GREEN WIRE - Connect onto the tacho signal / ignition coil negative wire.Once installed, when ignition is switched on the unit will flash several times indicating that it is receiving power.

NOTE: The following ECU wiring information is to be used as a guideline only. On various makes and models ECU pin outs may differ from those illustrated. Please have the installation carried out by a professional auto electrician.

5

Troubleshooting Guide
• Shiftlight...