El Arte Y La Ciencia-Relevadores

1

THE PHILOSOPHY OF PROTECTIVE RELAYING
WHAT IS PROTECTIVE RELAYING?
We usually think of an electric power system in terms of its more impressive parts–the big generating stations, transformers, high-voltage lines, etc. While these are some of the basic elements, there are many other necessary and fascinating components. Protective relaying is one of these. The role of protective relaying inelectric-power-system design and operation is explained by a brief examination of the over-all background. There are three aspects of a power system that will serve the purposes of this examination. These aspects are as follows: A. Normal operation B. Prevention of electrical failure. C. Mitigation of the effects of electrical failure. The term “normal operation” assumes no failures of equipment,no mistakes of personnel, nor “acts of God.” It involves the minimum requirements for supplying the existing load and a certain amount of anticipated future load. Some of the considerations are: A. Choice between hydro, steam, or other sources of power. B. Location of generating stations. C. Transmission of power to the load. D. Study of the load characteristics and planning for its futuregrowth. E. Metering F. Voltage and frequency regulation. G. System operation. E. Normal maintenance. The provisions for normal operation involve the major expense for equipment and operation, but a system designed according to this aspect alone could not possibly meet present-day requirements. Electrical equipment failures would cause intolerable outages. There must be additional provisions to minimizedamage to equipment and interruptions to the service when failures occur. Two recourses are open: (1) to incorporate features of design aimed at preventing failures, and (2) to include provisions for mitigating the effects of failure when it occurs. Modern

THE PHILOSOPHY OF PROTECTIVE RELAYING

1

power-system design employs varying degrees of both recourses, as dictated by the economicsof any particular situation. Notable advances continue to be made toward greater reliability. But also, increasingly greater reliance is being placed on electric power. Consequently, even though the probability of failure is decreased, the tolerance of the possible harm to the service is also decreased. But it is futile-or at least not economically justifiable-to try to prevent failures completely.Sooner or later the law of diminishing returns makes itself felt. Where this occurs will vary between systems and between parts of a system, but, when this point is reached, further expenditure for failure prevention is discouraged. It is much more profitable, then, to let some failures occur and to provide for mitigating their effects. The type of electrical failure that causes greatest concernis the short circuit, or “fault” as it is usually called, but there are other abnormal operating conditions peculiar to certain elements of the system that also require attention. Some of the features of design and operation aimed at preventing electrical failure are: A. Provision of adequate insulation. B. Coordination of insulation strength with the capabilities of lightning arresters. C. Use ofoverhead ground wires and low tower-footing resistance. D. Design for mechanical strength to reduce exposure, and to minimize the likelihood of failure causable by animals, birds, insects, dirt, sleet, etc. E. Proper operation and maintenance practices. Some of the features of design and operation for mitigating the effects of failure are: A. Features that mitigate the immediate effects of anelectrical failure. 1. Design to limit the magnitude of short-circuit current.1 a. By avoiding too large concentrations of generating capacity. b. By using current-limiting impedance. 2. Design to withstand mechanical stresses and heating owing to short-circuit currents. 3. Time-delay undervoltage devices on circuit breakers to prevent dropping loads during momentary voltage dips. 4. Ground-fault...