Electronic Modular Switching System

Electronic Modular Switching System

Please read this manual before connecting the Electronic Modular Switching System.

ELECTRONIC MODULAR SW ITCHING SYSTEM

POWER

MODEL KX-T206E

Thank you for purchasing the Panasonic Model KX-T206E, Electronic Modular Switching System.

System Component
Model No. Service Unit Telephone KX-T206E Description Electronic Modular Switching SystemKX-T7130E KX-T7020E KX-T7050E

Proprietary telephone with display Proprietary telephone Proprietary telephone

Optional Equipment

KX-T20691E DISA/FAX Detect Card KX-T30865E Doorphone

Notes

• In this Installation Manual, the suffix “E” of each model number is omitted. • A proprietary telephone is abbreviated as “PT”. • A single line telephone is abbreviated as “SLT”.
APPROVED forconnection to telecommunication systems specified in the instructions for use subject to the conditions set out in them.

504100

The serial number of this product may be found on the label affixed to the bottom of the unit. You should note the serial number of this unit in the space provided and retain this book as a permanent record of your purchase to aid in identification in the event oftheft. MODEL NO.: KX-T206E SERIAL NO.: For future reference DATE OF PURCHASE NAME OF DEALER DEALER’S ADDRESS

Important Information
FOR YOUR SAFETY PLEASE READ THE FOLLOWING TEXT CAREFULLY.
This appliance is supplied with a moulded three pin mains plug for your safety and convenience. A 5 amp fuse is fitted in this plug. Should the fuse need to be replaced please ensure that the replacement fusehas a rating of 5 amps and that it is approved by ASTA or BSI to BS1362. Check for the ASTA mark or the BSI mark on the body of the fuse. If the plug contains a removable fuse cover you must ensure that it is refitted when the fuse is replaced. If you lose the fuse cover the plug must not be used until a replacement cover is obtained. A replacement fuse cover can be purchased from your localPanasonic Dealer. IF THE FITTED MOULDED PLUG IS UNSUITABLE FOR THE SOCKET OUTLET IN YOUR HOME THEN THE FUSE SHOULD BE REMOVED AND THE PLUG CUT OFF AND DISPOSED OF SAFELY. THERE IS A DANGER OF SEVERE ELECTRICAL SHOCK IF THE CUT OFF PLUG IS INSERTED INTO ANY 13 AMP SOCKET. If a new plug is to be fitted please observe the wiring code as shown below. If in any doubt please consult a qualified electrician.WARNING : THIS APPLIANCE MUST BE EARTHED. IMPORTANT : The wires in this mains leads are coloured in accordance with the following code: Green-and-yellow: Earth Blue: Neutral Brown: Live As the colours of the wires in the mains lead of this appliance may not correspond with the coloured markings identifying the terminals in your plug, proceed as follows. The wire which is coloured GREEN-AND-YELLOWmust be connected to the terminal in the plug which is marked with the letter E or by the safety earth symbol or coloured GREEN or GREEN-AND-YELLOW. The wire which is coloured BLUE must be connected to the terminal in the plug which is marked with the letter N or coloured BLACK. The wire which is coloured BROWN must be connected to the terminal in the plug which is marked with the letter L orcoloured RED. How to replace the fuse : Open the-fuse compartment with a screwdriver and replace the fuse and fuse cover.

3

Important Information
This equipment should be used on PSTN lines requiring 2-wire Loop calling unguarded clearing with Loop Disconnect or DTMF address signalling. The equipment must be connected to direct extension lines and a payphone should not be connected as anextension. Operation in Power Failure In the event of a power failure, CO2 is connected to extension 22 automatically. • Set the Dialling Mode (Tone or Pulse) of your telephone, according to the CO line. • 999 and 112 can be dialled on the apparatus for the purpose of making outgoing calls to the BT emergency (999) and (112) service. Satisfactory performance can not be guaranteed for every allowed...