Formato ieee

(
TITULO ESPECIFICO Y COMPLETO DEL REPORTE
First A. Author, Second B. Author, Third C. Autor…. Etc Facultad de Ingeniería Electrónica,Universidad Santo Tomàs Bogotá, Colombia

Resumen – Este resumen realizarlo en español. Que sea lo mas conciso y preciso. Por ejemplo: Se diseña un flotador de geometría regular, a partir del cualse determina experimentalmente su metacentro y su periodo de vibración a partir del uso de técnicas fotográficas. Se estudia su comportamiento …. etc.
Abstract—El mismo resumen pero en Inglés.

Indice de Términos— Colocar palabras claves

Introduccion

T
HIS document is a template for Microsoft Word versions 6.0 or later. If you are reading a paper version of this document, pleasedownload the electronic file, TRANS-JOUR.DOC,from http://www.ieee.org/organizations/pubs/transactions/stylesheets.htm so you can use it to prepare your manuscript. If you would prefer to use LATEX, download IEEE’s LATEX style and sample files from the same Web page. Use these LATEX files for formatting, but please follow the instructions in TRANS-JOUR.DOC or TRANS-JOUR.PDF.
If your paper is intendedfor a conference, please contact your conference editor concerning acceptable word processor formats for your particular conference.
When you open TRANS-JOUR.DOC, select “Page Layout” from the “View” menu in the menu bar (View | Page Layout), which allows you to see the footnotes. Then type over sections of TRANS-JOUR.DOC or cut and paste from another document and then use markup styles. Thepull-down style menu is at the left of the Formatting Toolbar at the top of your Word window (for example, the style at this point in the document is “Text”). Highlight a section that you want to designate with a certain style, then select the appropriate name on the style menu. The style will adjust your fonts and line spacing. Do not change the font sizes or line spacing to squeeze more text intoa limited number of pages. Use italics for emphasis; do not underline.
To insert images in Word, position the cursor at the insertion point and either use Insert | Picture | From File or copy the image to the Windows clipboard and then Edit | Paste Special | Picture (with “Float over text” unchecked).
IEEE will do the final formatting of your paper. If your paper is intended for aconference, please observe the conference page limits.

Procedure for Paper Submission

1 Review Stage

Please check with your editor on whether to submit your manuscript by hard copy or electronically for review. If hard copy, submit photocopies such that only one column appears per page. This will give your referees plenty of room to write comments. Send the number of copies specified by youreditor (typically four). If submitted electronically, find out if your editor prefers submissions on disk or as e-mail attachments.
If you want to submit your file with one column electronically, please do the following:
--First, click on the View menu and choose Print Layout.
--Second, place your cursor in the first paragraph. Go to the Format menu, choose Columns, choose one column Layout,and choose “apply to whole document” from the dropdown menu.
--Third, click and drag the right margin bar to just over 4 inches in width.
The graphics will stay in the “second” column, but you can drag them to the first column. Make the graphic wider to push out any text that may try to fill in next to the graphic.

2 Final Stage

When you submit your final version, after your paper hasbeen accepted, print it in two-column format, including figures and tables. Send three prints of the paper; two will go to IEEE and one will be retained by the Editor-in-Chief or conference publications chair.
You must also send your final manuscript on a disk, which IEEE will use to prepare your paper for publication. Write the authors’ names on the disk label. If you are using a Macintosh,...