Hmi delta

Preface
Thank you for purchasing DELTA’s DOP-B series. This quick start will be helpful in the installation, wiring and inspection of Delta HMI. Before using the product, please read this quick start to ensure correct use. You should thoroughly understand all safety precautions before proceeding with the installation, wiring and operation. Place this quick start in a safe location for futurereference. Please observe the following precautions:    Install the product in a clean and dry location free from corrosive and inflammable gases or liquids. Ensure that all wiring instructions and recommendations are followed. Ensure that HMI is correctly connected to a ground. The grounding method must comply with the electrical standard of the country (Please refer to NFPA 70: NationalElectrical Code, 2005 Ed.). Do not modify or remove wiring when power is applied to HMI. Do not touch the power supply during operation. Otherwise, it may cause electric shock. For the information of HMI software operation, and software installation, please refer to the HMI software manual.

  

If you have any questions during operation, please contact our local distributors or Delta salesrepresentative. The content of this quick start may be revised without prior notice. Please consult our distributors or download the most updated version at http://www.delta.com.tw/industrialautomation.

Safety Precautions
Carefully note and observe the following safety precautions when receiving, inspecting, installing, operating, maintaining and troubleshooting. The following words, DANGER, WARNING andSTOP are used to mark safety precautions when using the Delta’s HMI product. Failure to observe these precautions may void the warranty!

Installation  Comply with quick start for installation. Otherwise it may cause equipment
damage.

 Do not install the product in a location that is outside the stated specification for
the HMI. Failure to observe this caution may result in electric shock,fire, or explosion.  Do not install the product in a location where temperatures will exceed specification for the HMI. Failure to observe this caution may result in abnormal operation or damage the product.  Please note that this equipment has obtained EMC registration for commercial use. In the event that it has been mistakenly sold or purchased, please exchange it for equipment certified forhome use.  Do not use this product as an alarm device for disaster early warning that may result in personal injury, equipment damage, or system emergency stop.

Wiring  Connect the ground terminals to a class-3 ground (Ground resistance should not
exceed 100Ω). Improper grounding may result in communication error, electric shock or fire.

English-1

Operation  The users should use DeltaScreen Editor software to perform editing in Delta's
HMI product. To perform editing and confirming HMI programs without using Delta Screen Editor software in Delta's HMI product may result in abnormal operation.  To prevent the personal injury and equipment damage, when designing HMI programs, please ensure that a communication error occurred between Delta’s HMI product and the connecting controlleror equipment will not result in system failure or malfunction.  Please be sure to backup the screen data and HMI programs in case they are lost, accidentally deleted or worse.

 Do not modify wiring during operation. Otherwise it may result in electric shock
or personal injury.

 Never use a hard or pointed object to hit or strike the screen as doing this may

damage the screen and let thescreen has not respond at all, and then cause HMI to work abnormally.

Maintenance and Inspection  Do not touch any internal or exposed parts of the HMI as electrical shock may  Do not remove operation panel while power is on. Otherwise electrical shock may
result. result.

 Wait at least 10 minutes after power has been removed before touching any HMI

terminals or performing any wiring and/or...