Instalacion De Faros

OPTILUX INSTALLATION INSTRUCTIONS
MODEL 2020

RED

LAMP
FUSE

FOG LAMP
RELAY

15A

BLACK

WHITE
GROUND

GROUND
DRIVING LAMP
RELAY

RED

87

86

85 BLUE

WHITE

GROUNDBROWN
WHITE

BLACK

WHITE

30
VEHICLE
GROUND

RED

RED

85 BLUE

86

BLACK

BATTERY

87

RED 30

2A

GREEN

GROUND

BLUE
GROUND

WHITE

BACK OF
SWITCHMounting
1.
2.

Consult your local and state regulations regarding minimum and maximum mounting height above the ground, or specific requirements.
Mount both of the lamps at the same height. Positionthe lamps at an equal distance from the center of the vehicle and as far apart as
possible.
CAUTION: Make sure the auxiliary lamps do not restrict airflow to the radiator or obstruct the headlamps,turn signals, or marker lamps.
3. Mark the mounting points on the bumper and drill 5/32” diameter holes for pendant or upright mounting.
4. Attach lamp base to the bumper. Do not tighten completelyuntil lamp is properly aimed.
Wiring Installation (refer to the above diagram)
CAUTION: Route wires away from moving parts or excessive heat.
1. Disconnect the battery.
2. Attach the BLACK wiresfrom the lamps to the vehicle ground.
3. Position the relays upright on the battery side of the engine compartment in an area that is not exposed to water spray, excessive heat,
or moving parts.Make sure the relays are mounted close enough to the battery so the RED power lead will easily reach the positive (+)
terminal of the battery.
4. Connect the RED wire to the positive (+) batteryterminal and to the fog lamp relay terminal labeled 30.
5. Connect the BLACK wire from the fog lamp relay terminal labeled 30 to the driving lamp relay terminal labeled 30.
6. Route the WHITE wire fromthe driving lamp relay terminal labeled 30 to the switch.
7. Route the RED and WHITE wires from the lamps to the relay.
8. Connect the RED wire to the lamp terminals and to the fog lamp relay...