Iso/Iec 17025:2005(E)
INTERNATIONAL STANDARD
ISO/IEC 17025
Second edition 2005-05-15
General requirements for the competence of testing and calibration laboratories
Exigences générales concernant la compétence des laboratoires d'étalonnages et d'essais
Reference number ISO/IEC 17025:2005(E)
© ISO 2005
ISO/IEC 17025:2005(E)
Thisis a preview - click here to buy the full publication
PDF disclaimer
This PDF file may contain embedded typefaces. In accordance with Adobe's licensing policy, this file may be printed or viewed but shall not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In downloading this file, parties accept therein theresponsibility of not infringing Adobe's licensing policy. The ISO Central Secretariat accepts no liability in this area. Adobe is a trademark of Adobe Systems Incorporated. Details of the software products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation parameters were optimized for printing. Every care has been taken to ensure that the file issuitable for use by ISO member bodies. In the unlikely event that a problem relating to it is found, please inform the Central Secretariat at the address given below.
© ISO 2005 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and microfilm, withoutpermission in writing from either ISO at the address below or ISO's member body in the country of the requester. ISO copyright office Case postale 56 • CH-1211 Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 749 09 47 E-mail copyright@iso.org Web www.iso.org Published in Switzerland
ii
© ISO 2005 — All rights reserved
This is a preview - click here to buy the full publication
ISO/IEC17025:2005(E)
Contents
Page
Foreword ............................................................................................................................................................. v Introduction ....................................................................................................................................................... vi 1 2 3 4 4.1 4.2 4.34.3.1 4.3.2 4.3.3 4.4 4.5 4.6 4.7 4.8 4.9 4.10 4.11 4.11.1 4.11.2 4.11.3 4.11.4 4.11.5 4.12 4.13 4.13.1 4.13.2 4.14 4.15 5 5.1 5.2 5.3 5.4 5.4.1 5.4.2 5.4.3 5.4.4 5.4.5 5.4.6 5.4.7 5.5 5.6 5.6.1 5.6.2 5.6.3 5.7 Scope...................................................................................................................................................... 1 Normative references........................................................................................................................... 2 Terms and definitions........................................................................................................................... 2 Management requirements.................................................................................................................. 2 Organization .......................................................................................................................................... 2 Management system............................................................................................................................. 3 Document control................................................................................................................................. 4 General ................................................................................................................................................... 4 Document approval and issue............................................................................................................. 4 Document changes...
Regístrate para leer el documento completo.