Iso iec 26514

INTERNATIONAL STANDARD

ISO/IEC 26514
First edition 2008-06-15

Systems and software engineering — Requirements for designers and developers of user documentation
Ingénierie du logiciel et des systèmes — Exigences pour les concepteurs et les développeurs de la documentation de l'utilisateur

Reference number ISO/IEC 26514:2008(E)

Файл загружен с http://www.ifap.ru

© ISO/IEC2008

ISO/IEC 26514:2008(E)

PDF disclaimer
This PDF file may contain embedded typefaces. In accordance with Adobe's licensing policy, this file may be printed or viewed but shall not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In downloading this file, parties accept therein the responsibility of notinfringing Adobe's licensing policy. The ISO Central Secretariat accepts no liability in this area. Adobe is a trademark of Adobe Systems Incorporated. Details of the software products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation parameters were optimized for printing. Every care has been taken to ensure that the file is suitable for use by ISOmember bodies. In the unlikely event that a problem relating to it is found, please inform the Central Secretariat at the address given below.

COPYRIGHT PROTECTED DOCUMENT
© ISO/IEC 2008 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and microfilm,without permission in writing from either ISO at the address below or ISO's member body in the country of the requester. ISO copyright office Case postale 56 • CH-1211 Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 749 09 47 E-mail copyright@iso.org Web www.iso.org Published in Switzerland

ii

© ISO/IEC 2008 – All rights reserved

ISO/IEC 26514:2008(E)

Contents

PageForeword.......................................................................................................................................................... viii Introduction ....................................................................................................................................................... ix 1 2 2.1 2.2 3 4 5 6 6.1 6.2 6.3 6.3.1 6.3.2 6.4 6.5 6.6 6.6.1 6.6.26.6.3 6.6.4 6.6.5 6.6.6 6.7 7 7.1 7.1.1 7.1.2 7.1.3 7.2 7.2.1 7.2.2 8 8.1 8.1.1 8.1.2 8.2 8.2.1 8.2.2 8.3 8.3.1 8.3.2 9 9.1 9.2 9.3 Scope ..................................................................................................................................................... 1Conformance......................................................................................................................................... 3 Application of conformance ................................................................................................................ 3 Conformance situations....................................................................................................................... 3 Normative references........................................................................................................................... 4 Terms and definitions........................................................................................................................... 4 User documentation process within the systems/software life cycle........................................... 10 Project requirements, objectives, andconstraints ......................................................................... 13 Project objectives ............................................................................................................................... 13 User documentation requirements and constraints ....................................................................... 14 Project goals and constraints...