Juniper Manual

Conceptos y ejemplos
Manual de referencia de ScreenOS

Volumen 7:
Enrutamiento

Versión 5.3.0, Rev. B

Juniper Networks, Inc.
1194 North Mathilda Avenue
Sunnyvale, CA 94089
USA
408-745-2000

www.juniper.net
Número de pieza: 093-1665-000-SP, Revisión B

Copyright Notice
Copyright © 2005 Juniper Networks, Inc. All rights reserved.
Juniper Networks and the Juniper Networks logo are registeredtrademarks of Juniper Networks, Inc. in the United States and other countries. All other
trademarks, service marks, registered trademarks, or registered service marks in this document are the property of Juniper Networks or their respective
owners. All specifications are subject to change without notice. Juniper Networks assumes no responsibility for any inaccuracies in this document or for
anyobligation to update information in this document. Juniper Networks reserves the right to change, modify, transfer, or otherwise revise this publication
without notice.

FCC Statement
The following information is for FCC compliance of Class A devices: This equipment has been tested and found to comply with the limits for a Class A
digital device, pursuant to part 15 of the FCC rules. Theselimits are designed to provide reasonable protection against harmful interference when the
equipment is operated in a commercial environment. The equipment generates, uses, and can radiate radio-frequency energy and, if not installed and
used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential
area is likelyto cause harmful interference, in which case users will be required to correct the interference at their own expense.
The following information is for FCC compliance of Class B devices: The equipment described in this manual generates and may radiate radio-frequency
energy. If it is not installed in accordance with Juniper Network’s installation instructions, it may cause interference withradio and television reception.
This equipment has been tested and found to comply with the limits for a Class B digital device in accordance with the specifications in part 15 of the FCC
rules. These specifications are designed to provide reasonable protection against such interference in a residential installation. However, there is no
guarantee that interference will not occur in a particularinstallation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user
is encouraged to try to correct the interference by one or more of the following measures:

„

Reorient or relocate the receiving antenna.

„

Increase the separation between the equipment and receiver.

„

Consult the dealer or anexperienced radio/TV technician for help.

„

Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.

Caution: Changes or modifications to this product could void the user's warranty and authority to operate this device.

Disclaimer
THE SOFTWARE LICENSE AND LIMITED WARRANTY FOR THE ACCOMPANYING PRODUCT ARE SET FORTH IN THE INFORMATION PACKETTHAT SHIPPED
WITH THE PRODUCT AND ARE INCORPORATED HEREIN BY THIS REFERENCE. IF YOU ARE UNABLE TO LOCATE THE SOFTWARE LICENSE OR LIMITED
WARRANTY, CONTACT YOUR JUNIPER NETWORKS REPRESENTATIVE FOR A COPY.

Writer: Kristine Conley
Editor: Lisa Eldridge

ii

„

Contenido
Acerca de este volumen

ix

Convenciones del documento .........................................................................ix
Convenciones de la interfaz de línea de comandos (CLI) ........................... x
Convenciones para las ilustraciones ......................................................... xi
Convenciones de nomenclatura y conjuntos de caracteres ...................... xii
Convenciones de la interfaz gráfica (WebUI) .......................................... xiii
Documentación de Juniper Networks...