Laboratorio 2
Introduction
In this lab we observed themeasurement of different objects weight, density and volume. As well as converting metric units from one to the other. This was to make a clear understanding on the steps used to convert one metric unitto the other. This also helps to develop the knowledge of the equations for volume and density an apply them to the experiment.
Materials
* Metric ruler
* Lab book
* 200 ml beaker
*100 ml graduated cylinder
* Rock
* Glass marble
* Room tempertature water
* Cold water
* Hot water
* Thermometer
* Triple beam balance
* Pencil
* Nickel
*Paper clip
* Cup
* 1 gallon mil jug
Methods
Procedure 2.1
We measured the length, width, and thickness of the lab manual, out heights, the height of a 200ml beaker and the height of theceiling. After each measurement we recorded our results.
Procedure 2.2
Using the graduated cylinder, we counted how many milliliters it took to fill a cup and a gallon milk jug provided in the lab. Werecorded the results that we obtained.
Procedure 2.3
Using the graduated cylinder, we filled it up to the 70 millimeter mark. We proceeded to place the rock into the graduated cylinder and the waterrose; we repeated these steps again using the glass marble. After we obtained this information we recorded our results
Procedure 2.5
We measured the mass of the nickel, paperclip, pencil, rock, anempty 100ml beaker and a 100ml beaker containing 50 ml of water. After we received these readings we recorded our results.
Procedure 2.6
In this procedure we obtained a thermometer that as...
Regístrate para leer el documento completo.