Libres Informasiones

Instructions for use
WASHING MACHINE Contents
GB
English,1

GB

F
Français,13

Installation, 2-3 FA
,25

Unpacking and levelling Connecting the electricity and water supplies The first wash cycle Technical data

Description of the washing machine, 4-5 AR
, 37

UK
Óêðà¿íñüêà,49

Control panel Display

Running a wash cycle, 6 Wash cycles and options, 7
Table of wash cyclesWash options

IWE 7105

Detergents and laundry, 8
Detergent dispenser drawer Preparing the laundry Special wash cycles Load balancing system

Precautions and tips, 9

General safety Disposal Opening the porthole door manually

Care and maintenance, 10

Cutting off the water or electricity supply Cleaning the washing machine Cleaning the detergent dispenser drawer Caring for the doorand drum of your appliance Cleaning the pump Checking the water inlet hose

Troubleshooting, 11 Service, 12

1

Installation
GB

 This instruction manual should be kept in a safe place for future reference. If the washing machine is sold, transferred or moved, make sure that the instruction manual remains with the machine so that the new owner is able to familiarise himself/herself withits operation and features.  Read these instructions carefully: they contain vital information relating to the safe installation and operation of the appliance.

Levelling the machine correctly will provide it with stability, help to avoid vibrations and excessive noise and prevent it from shifting while it is operating. If it is placed on carpet or a rug, adjust the feet in such a way as toallow a sufficient ventilation space underneath the washing machine.

Connecting the electricity and water supplies
Connecting the water inlet hose

Unpacking and levelling
Unpacking

1. Remove the washing machine from its packaging. 2. Make sure that the washing machine has not been damaged during the transportation process. If it has been damaged, contact the retailer and do not proceed anyfurther with the installation process. 3. Remove the 4 protective screws (used during transportation) and the rubber washer with the corresponding spacer, located on the rear part of the appliance (see figure).

1. Connect the supply pipe by screwing it to a cold water tab using a ¾ gas threaded connection (see figure). Before performing the connection, allow the water to run freely until it isperfectly clear. 2. Connect the inlet hose to the washing machine by screwing it onto the corresponding water inlet of the appliance, which is situated on the top righthand side of the rear part of the appliance (see figure). 3. Make sure that the hose is not folded over or bent.

4. Close off the holes using the plastic plugs provided. 5. Keep all the parts in a safe place: you will need themagain if the washing machine needs to be moved to another location.

 Packaging materials should not be used as toys for children.
Levelling

 The water pressure at the tap must fall within the values indicated in the Technical details table (see next page).  If the inlet hose is not long enough, contact a specialised shop or an authorised technician.  Never use second-hand hoses.  Usethe ones supplied with the machine.

1. Install the washing machine on a flat sturdy floor, without resting it up against walls, furniture cabinets or anything else. 2. If the floor is not perfectly level, compensate for any unevenness by tightening or loosening the adjustable front feet (see figure); the angle of inclination, measured in relation to the worktop, must not exceed 2°.

2Connecting the drain hose

 Do not use extension cords or multiple sockets.
Connect the drain hose, without bending it, to a drainage duct or a wall drain located at a height between 65 and 100 cm from the floor;

GB

 The cable should not be bent or compressed.  The power supply cable must only be replaced by authorised technicians.
Warning! The company shall not be held responsible in...