Manual De Mantenimiento Bally Refrigeradores

B40-CU-IM-13
1068157








Installation and Maintenance
Instructions

for

Air-Cooled, Remote and Water-Cooled
Condensing Units



[pic]


[pic]

[pic]


Bally Refrigerated Boxes Inc.,General Sales, Manufacturing and Engineering
135 Little Nine Drive, Morehead City, NC 28557
Phone: 800-24BALLY, 252-240-2829 Fax: 252-240-0384
Service and Warranty
Phone: 800-344-9302, 610-337-8600 Fax: 610-337-0431
Visit our web site atwww.ballyrefboxes.com
Table of Contents


Pages

General Safety, Inspection & General Warranty Policy 3
[pic]
Handling, Placement & Installation 4 – 6
[pic]
Electrical Information & Wiring Diagrams 7 – 14
[pic]
Refrigerant Piping 15 – 16
[pic]
Water-Cooled Condensers, Piping & Flow Rates 17 – 18
[pic]
System Accessories 19
[pic]
Leak Testing,Evacuation & Dehydration 20
[pic]
Line Insulation 21
[pic]
Refrigerant Charging 21 – 23
[pic]
Compressor Oils 24 – 25
[pic]
System Start-up Check List 26 – 27
[pic]
Low Temperature Room Pull-Down 27
[pic]
Checking Compressor & Evaporator Superheat 28
[pic]
System Operational Check List 29
[pic]
System Troubleshooting 30 – 32
[pic]
Customer Instructions33
[pic]
Maintenance Program 33
[pic]

Service Parts Availability 33

[pic]
Finished Goods Warranty & Service Log 34
[pic]
Warranty Activation Certificate 35
[pic]


















2
General Safety

IMPORTANT SAFETY NOTE
Only a qualified refrigeration mechanic who is familiar withrefrigeration systems and components, including all controls should perform the installation and start-up of the system. To avoid potential injury, use care when
working around coil surfaces (if applicable) or sharp edges of metal cabinets. All piping and electrical wiring should be installed in accordance with all applicable codes, ordinances and local by-laws.

WARNINGAlways disconnect and lock off the main power supply on any system that will be worked on to avoid accidental start up of the equipment.

Inspection

Inspect all equipment before unpacking for visible signs of damage or loss. Check shipping list against material received to ensure shipment is complete.

IMPORTANT: Remember, you, the consignee, must makeany claim necessary against the transportation company. Shipping damage or missing parts, when discovered at the outset, will prevent later unnecessary and costly delays. If damage or loss during transport is evident, make claim to carrier, as this will be their responsibility, not that of the manufacturer.

Should carton be damaged, but damage to equipment is not obvious, a claim should befiled for “concealed damage” with the carrier.

IMPORTANT: Check the electrical ratings on the unit to make sure they correspond to those ordered and to electrical power available at the job site. Save all shipping papers, tags, and instruction sheets for reference by installer and owner.





General Warranty Policy

Please refer to the“Finished Goods Warranty” on page 34.

























3
Handling, Placement and Installation

IMPORTANT: When selecting a location for the condensing unit, consideration should be given to some of the following:
(a) Loading capacity of the floor or roof. Check building codes for weight distribution requirements. (b) Distance to suitable...