Manual De Mantenimiento Preventivo Para Pc En Ingles

Fundacion San Mateo

Preventive Maintenance Manual
Jeimer Bolañoz
Carlos Dias
Jose Vallecilla

Introduccion Al Hadware

17 De Octubre Del 2012
Bogota D.C

INTRODUCTION

What we want with this guide is to make our computer maintenance to avoid damage in the future and achieve a longer life for your PC, then show the basic steps to achieve properly do this maintenance withoutdamaging any of parts of our computer

SPECIFIC OBJECTIVES
 
• Build a good maintenance to our computer

• Use proper tools

• Generate a care for our computer

• Know some computer components

OBJECTIVES GENERAL

• Play a good preventive maintenance for your PC

MATERIALS NEED TO PERFORM PREVENTIVE MAINTENANCE
 
• FLAT TIP SCREWDRIVER
These screwdrivers are used to remove the screwsthat contain our pc cabinet

• HANDLE ESD
This handle is very useful as we discharge the static energy that we have in our body, as most of our computer's components are very sensitive to energy and if we do not use this handle could damage some of our components

• Isopropyl alcohol
This alcohol is very useful for cleaning our pc as it is a compound that dries too fast and helps clean fatvery effectively.

• BLOWER
This helps us to clean up all the dust in hard to reach parts (must be a blower as other air can damage the components of our pc)

• BRUSHES
Small medium and large these are very useful to make a cleaning powder containing pieces depending on their size was used brush

• Tweezers
They serve to maneuver and reach small parts

• BAYETILLA
Used to clean the bodyand to not lose us

• DRAFT
This serves to remove dirt and grease with our memories in contacts

• antistatic bag
This bag serves to prevent static electricity within these

MANUAL FOOTSTEPS OF OUR PREVENTIVE MAINTENANCE

Step 1: See if our computer is well and everything is in order and shut down
Step 2: Disconnect all components of your PC from the electrical outlet and the CPURECOMMENDATION
- Perform cleaning tasks in a location with good lighting
- Wear the strap handle and wait 5 minutes before opening our pc this is so that our energy does not damage any components
- See exactly where the parts are disconnected or if possible remove notes the specific location of each
- If after cleaning everything and connect all lights not connected something wrong maybe do notdespair looks everything is in place and try again
Step 3: Then we proceed to uncover our good looking chassis forming screws are placed and store well so there is no loss of any of them

Step 4: Next we will turn off our power source of our board then retired after having disconnected from all of our pc components, proceed to clean, basically what we have to do is clean our brush and blow allour components we can see, (careful with our ventilated because if we put our blower we can directly damage since the fan has turned one-way and if we put our blower that sense we can modify or damage our fan)

Step 5: After you have removed our source of power and have done their respective cleaning buses proceed to disconnect our data and our internal components of our board

Step 6: Now weremove the memories of their sockets and proceed to clean the contacts with our draft if our draft residues remain in the memories we will clean our brush, after having clean our memories we will leave them in an antistatic bag

Step 7: Then withdraw the sink, but arem carefully as this is very delicate, removing processor step very carefully and then we will put it in an antistatic bag

Step8: Then continue removing the input & Storage dipositive one of our flat-blade screwdriver and clean with our brush if necessary (hard disk, CD ROM)

Step 9: After the withdrawal, cards, cables, heat sinks and devices on board, proceed to clean the board very carefully with our finishing brush so our mantemiento of all physical parts of our computer

Step 10: Then what we will do is...