Manual De Servicio De Fabricador De Hielo Scotsman

CS60
INTRODUCTION
This service manual covers the installation, operation, maintenance and service of this ice machine.

Table of Contents
INTRODUCTION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Page 1 Page 2 Page 3 Page 4 Page 5 Page 6 Page 7 Page 8 Page 9 Page 10 Page 11 Page 12 Page 13 Page 14 Page 15 Page 16 Page 17 SPECIFICATIONS . . . . . . . . . . . . . . . . . . . . .. . . . . . . . . FOR THE INSTALLER . . . . . . . . . . . . . . . . . . . . . . . . . . . .

FOR THE PLUMBER . . . . . . . . . . . . . . . . . . . . . . . . . . . . . INSTALLATION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

INITIAL START UP . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . HOW IT WORKS: COMPONENT DESCRIPTION . . . . . . . . . . . . . . . . . .COMPONENT LOCATION . . . . . . . . . . . . . . . . . . . . . . . . . . . HOW IT WORKS: WATER . . . . . . . . . . . . . . . . . . . . . . . . . . . HOW IT WORKS: REFRIGERATION HOW IT WORKS: REFRIGERATION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

OPERATION & ADJUSTMENT: OPERATING CHARACTERISTICS SANITIZING AND CLEANING SERVICEDIAGNOSIS SERVICE DIAGNOSIS

. . . . . . . . . . . . . . . . . . . . . . . . .

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

REMOVAL AND REPLACEMENT . . . . . . . . . . . . . . . . . . . . . . . . REMOVAL AND REPLACEMENT . . . . . . . . . . . . . . . . . . . . . . . .

Service Parts lists and Wiring diagrams are located in thecenter of this manual, printed on yellow paper.

This manual was printed on recycled paper. Keep this manual for future reference. Note the Warning symbol, it marks a possible hazard.

January 1995 Page 1

CS60
SPECIFICATIONS
17 9/16"

28.42"

5.5" 18"

20.6"

NAMEPLATE LOCATION
3/4" HOSE COUPLING THREAD 25/32" 2 .2" POWER 2 .2"

1 .76" 5 .4"

3.83"

SPECIFICATIONS
ModelNumber Basic Max. Fuse Electrical Size 28.42 X 18 X 20.6 Medium 115/60/1 15 Dimensions H" X W" X D" Cube Size Refrigerant Charge is 12 oz of R-22. Always go by the namepate.

CS60MAS-1A

The finish is stainless steel. Minimum circuit ampacity is used to determine wire size per national electric code. Refrigerant type is R-22. OPERATING REQUIREMENTS: MINIMUM MAXIMUM Air Temperature WaterTemperature Water Pressure Voltage 50 F. 400 F. 20 PSIG 103.5V
0

100 F. 1000 F. 100 PSIG 126.5V

0

Scotsman assumes no liability or responsibility of any kind for products manufactured by Scotsman that have been altered in any way, including the use of any parts and/or other components not specifically approved by Scotsman. Scotsman reserves the right to make design changes and/or improvements atany time. Specifications and designs are subject to change without notice.

Scotsman Ice Systems are designed and manufactured with the highest regard for safety and performance. They meet or exceed the standards of UL and NSF.

January 1995 Page 2

CS60
FOR THE INSTALLER
Location:
Prior consideration for the location shall include: • Air circulation: The front panel MUST remainunobstructed. Do not block with any type of • Indoors, with a minimum room temperature of 0 door or curtain. 50 F. and a maximum room temperature of 0 If the unit is built in, it will pull air in from the right 100 F. side of the front panel, and exhaust it out the left • Water temperature to the machine should be 0 0 side of the front panel. If the left side of the between 40 F. and 100 F. machine isleft open, warm air will be • Service Access. Allow enough space at the discharged from the left side panel. back of the cabinet for the utilities to be connected. Allow enough space for the machine to be pulled out from its installed IF BUILT IN, THIS SIDE location. Do not build a floor in front of the SHOULD BE TIGHT AGAINST machine that would prevent its removal. THE CABINET TO PREVENT
AIR...