Manual De Usuario Canon Mx360

MX360 / MX366 / MX368 MX410 / MX416 / MX418 MX420 / MX426 / MX428 SERVICE REFERENCE MANUAL

This manual focuses on differences from the base machines, MX340 / MX347 / MX348 and MX350 / MX357 / MX358. For other information (special notes on servicing, etc.), refer to the "MX340 / MX347 / MX348, MX350 / MX357 / MX358 Simplified Service Manual" (QY8-13CS-000).

QY8-13DD-000 Rev. 00

Dec. 2010Canon Inc.

(1/25)

Table of Contents

1. LIST OF ERROR DISPLAY / TROUBLESHOOTING ....................................................3
1-1. 1-2. 1-3. Operator Call Errors (Alarm Lamp Lit In Orange) ........................................................ 3 Service Call Errors (by Cyclic Blinking of Alarm and Power Lamps) ........................... 6 FAX Errors................................................................................................................... 7

2. ADJUSTMENT / SETTINGS........................................................................................12
2-1. 2-2. 2-3. 2-4. Service Mode ............................................................................................................. 12 PTT ParameterMode................................................................................................. 16 User Mode.................................................................................................................. 19 Special Notes on Servicing ........................................................................................ 20

(2/25)

1.

LIST OF ERROR DISPLAY / TROUBLESHOOTING
Errors andwarnings are displayed by the following ways: - Operator call errors are indicated by the Alarm lamp lit in orange, and the error and its solution are displayed on the LCD. - Messages during printing from a computer are displayed on the printer driver Status Monitor. - Error codes are printed in the "operator call/service call error record" area in EEPROM information print.

1-1. Operator Call Errors(Alarm Lamp Lit In Orange)
Buttons valid when an operator call error occurs: - ON button: To turn the printer off and on again. - OK button: To clear and recover from an error. In some operator call errors, the error will automatically be cleared when the cause of the error is eliminated, and pressing the OK button may not be necessary. - Stop button: To cancel the job at error occurrence, and toclear the error. Error Parts that are likely to be Error U No. Message on the LCD Solution code faulty No paper in the [1000] --- There is no paper. Set the paper in the rear - PE PWB unit rear tray. Load paper and press tray, and press the OK - Pick-up roller [OK]. button. - Drive unit - Logic board The paper output [1251] --- Paper output tray is Open the paper output tray, tray closed. closed.Open the paper and press the OK button. output tray and press [OK]. Paper jam. [1300] --- The paper is jammed. Remove the jammed paper, - PE PWB unit Clear the paper and and press the OK button. - Logic board press [OK]. Ink cartridge not [1401] U051 Print head is not Install the ink cartridge - Ink cartridge installed, or not installed. Install the properly. If the error is not - Carriage unitproperly installed. print head. cleared, the ink cartridge - Logic board may be defective. Replace the ink cartridge. Ink cartridge [1403] U052 The type of print head Re-set the ink cartridge. If - Ink cartridge temperature is incorrect. Install the the error is not cleared, the - Carriage unit sensor error. correct print head. ink cartridge may be - Logic board defective. Replace the ink cartridge.Non-supported [1485] U059 The following ink A non-supported ink - Ink cartridge ink cartridge cartridge cannot be cartridge is installed. Install - Carriage unit installed. recognized. the supported ink cartridge. - Logic board If the error is not cleared, the ink cartridge may be defective. Replace the ink cartridge.

(3/25)

Error Ink cartridge in a wrong position.

Error U No. Message...