Manual dwc tw7000 ( op. manual )

TW7000-MSOP

TW7000 HF TRANSCEIVER OPERATOR MANUAL

Datron World Communications Inc. Manual Part No. TW7000-MSOP Release Date: June 2001 Revision: F

3030 Enterprise Court Vista, CA 92083, U.S.A Phone: (760) 597-1500 Fax: (760) 597-1510 E-mail: sales@dtwc.com www.dtwc.com

© 2001 Datron World Communications Inc. (Datron) All rights reserved.

Datron World Communication Inc.
Thismanual, as well as the software described in it, is furnished under license and may only be used or copied in accordance with the terms of such license. The information in this manual is furnished for informational use only, is subject to change without notice, and should not be construed as a commitment by Datron. Datron assumes no responsibility or liability for any errors or inaccuracies that mayappear in this book. Except as permitted by such license, no part of this publication may be reproduced, stored in a retrieval system, or transmitted, in any form or by any means, electronic, mechanical, recording, or otherwise without the prior written permission of Datron.

Software License Agreement and Warranty
This software is licensed to the user (licensee) under the express terms andconditions of Datron’s software licensing policies and agreement as outlined below. By receiving and installing this software package the user (licensee) has indicated acceptance of the terms and conditions of this agreement presented herewith. As used in this document, the term “Software” shall mean the application or control software in machinereadable format and the hardware protection key, alongwith any or all supporting documentation, as well as all updated or enhanced versions of the program supplied to the user at later date(s). This software license does not include source code, and therefore, no license is granted with respect to source code of any kind utilized directly or indirectly in any Datron or Datron supplied third party product. Note, in some cases, covered software may beincluded in Datron products in RAM or ROM, and/or forms of machine readable code, not readily accessible to the user or licensee. In consideration of the terms and conditions of this agreement, Datron grants the user a non-exclusive, nontransferable license to install and operate one copy of the program. Licensee agrees not to attempt, aid, authorize, or direct any effort, either directly orindirectly to reverse engineer or reverse compile the Software. Licensee further agrees they or their agents are not authorized to make derivative versions or changes to the Software. Title to and ownership of the Software shall at all times remain with Datron and/or its licensors. Further, no license is granted to copy or reproduce in any form whatsoever the Software supplied without the expresswritten permission of Datron, prior to any such contemplated action. Datron may terminate this agreement and discontinue further warranty coverage at any time due to failure to comply with the terms and conditions of this agreement. In such an event, Datron will provide the user with written notice of such a “failure-to-comply” and the user will have 10 days to demonstrate that a remedy has beenimplemented. If the user fails to perform, the agreement will be terminated by further written notice

from Datron. Upon termination, the user shall immediately return all original Software, documentation, and any copies of each to Datron. This Software is licensed “AS IS” and Datron provides a warranty that covers the media upon which the Software is embedded for a period of 30 days from receipt ofthe product. Under this warranty policy Datron’s sole obligation shall be to replace or repair, at Datron’s discretion, any such media that in Datron’s opinion proves defective. The user is obligated to provide Datron with a detailed description of possible defects along with sample material such that Datron can reproduce the identified defects. By receipt and use, user (licensee) acknowledges...