Manual Router

How to setup an IPSec VPN connection between a DIR-130 and DI-80xHV
This setup example uses the following network settings:

In our example the IPSec VPN tunnel is established between two LANs:192.168.0.x and
192.168.1.x.
NOTE: It is essential to have private networks (LAN 1 and LAN 2) on different subnets.

D-Link Technical Support – How to setup an IPSec VPN connection between a DIR-130and DI-80xHV

Page 1 of 10

Configuration of the DIR-130
Step 1. Log into the DIR-130 by opening Internet Explorer and typing the LAN address of the
device. In our example we are using thedefault 192.168.0.1. Enter Username and Password
which you specified during the initial setup of the Firewall.
Step 2: Click on SETUP, select VPN SETTINGS, and select IPSec from the ADD VPN
PROFILEdropdown list and click Add.

D-Link Technical Support – How to setup an IPSec VPN connection between a DIR-130 and DI-80xHV

Page 2 of 10

Step 3: Configure the IPSec VPN as followed:
IPSECSETTING
•
•
•
•
•

Enable: check box to enable
Name: enter a name for the VPN
Encapsulation Mode:: Tunnel
Remote IP: select Site to Site and enter the remote gateway
Remote Local LAN Net/Mask: enter the remote network and remote subnet mask

Authentication: enter a Pre-shared Key (Pre-share key must match remote side)

PHASE 1
•

IKE Proposal List: leave at default (3DES, SHA1)PHASE 2

•

IPSec Proposal List: leave at default (3DES, SHA1)

Click Save Settings.

D-Link Technical Support – How to setup an IPSec VPN connection between a DIR-130 and DI-80xHV

Page 3 of10

D-Link Technical Support – How to setup an IPSec VPN connection between a DIR-130 and DI-80xHV

Page 4 of 10

Configuration of DI804HV/808HV
Step 1: Open your web browser and type in theIP address of the router (192.168.0.1 by
default). Enter the username (admin by default) and password (blank by default), and then
click OK.
In our setup we changed the IP of the unit to...