Manual scaner ls2280
SPECIAL OPERATING INSTRUCTIONS
2
LS2208-SR20291R
The LS 2208-SR20291R differs from the standard in the following ways:
•
Allows programmability via the hostcomputer’s RS232 interface and bar code menu equivalent to the LS4004-E075. (Refer to the LS4004-E075 Special Operating Instructions, p/n 73-16171-075.) The new extended length range of Code 128 is 1- 32. (The standard length range of Code 128 is 6 - 32.) Custom code ID ‘g’ was added to Code 93. The scanner accepts new commands and performs the actions specified in the table below. CommandDC
• • • •
•
• •
Action Code 39 enabled for any length Code 93 enabled for any length Code 128 enabled for any length Codabar enabled for any length
All other symbologies aredisabled. DD
• • •
Set DCA mode 2 Interleaved 2 of 5 enabled + transmit check digit Minimum length of 6 maximum length of 40
All other symbologies are disabled.
Special OperatingInstructions
•
3
A new parameter allows Intellistand mode to be enabled and disabled when the scanner is placed in a scan stand. The default is disable Intellistand. Scan a bar code below toenable and disable Intellistand mode.
Disable Intellistand Mode (Default)
Enable Intellistand Mode
Service Information
Before you use the unit, it must be configured to operate in yourfacility’s network and run your applications. If you have a problem running your unit or using your equipment, contact your facility’s Technical or Systems Support. If there is a problem with theequipment, they will contact the Symbol Global Customer Interaction Center. Locate Symbol Global Customer Interaction Centers by visiting: www.symbol.com/contactsupport. For the latest versionof this guide go to: http://www.symbol.com/manuals.
73E-58808-291R Revision A - December 2006 Symbol Technologies, Inc. One Symbol Plaza Holtsville, N.Y. 11742-1300 http://www.symbol.com
Regístrate para leer el documento completo.