Manual udc

UDC 6300 Process Controller Product Manual
51-52-25-45
1/03 Rev. C

Industrial Measurement and Control

Copyright, Notices, and Trademarks
Printed in U.S.A. – © Copyright 1999 by Honeywell Inc. Rev. C

While this information is presented in good faith and believed to be accurate, Honeywell disclaims the implied warranties of merchantability and fitness for a particular purpose andmakes no express warranties except as may be stated in its written agreement with and for its customer. In no event is Honeywell liable to anyone for any indirect, special or consequential damages. The information and specifications in this document are subject to change without notice.

This document was prepared using Information Mapping® methodologies and formatting principles.

UDC6300 is a trademark of Honeywell Inc. Information Mapping is a trademark of Information Mapping Inc.

Industrial Measurement and Control Honeywell Inc. 1100 Virginia Drive Fort Washington, PA 19034

ii

UDC 6300 Process Controller Product Manual

1/03

About This Publication
How this manual is organized

This Product Manual is divided into 11 sections. These sections contain allthe information you need to configure, operate, monitor, and troubleshoot your controller. To find information quickly, use the comprehensive Table of Contents in the front of the manual and the Index located in the back of the manual. The device described herein has been manufactured and tested for correct operation and is warranted as follows: The Process Controller carries an 18 monthwarranty. This warranty includes immediate technical assistance via a toll free telephone number and complete replacement of the controller, if necessary.

Warranty

Contacts
World Wide Web The following lists Honeywell’s World Wide Web sites that will be of interest to our industrial automation and control customers.
Honeywell Organization Corporate Industrial Measurement and ControlInternational WWW Address (URL) http://www.honeywell.com http://www.honeywell.com/imc http://www.honeywell.com/Business/global.asp

Telephone
Contact us by telephone at the numbers listed below.
Organization United States and Canada Asia Pacific Europe Latin America Honeywell Inc. Honeywell Asia Pacific Inc. Hong Kong Honeywell PACE, Brussels, Belgium Honeywell Inc., Sunrise, Florida U.S.A.Phone Number 1-800-423-9883 1-800-525-7439 (852) 2829-8298 [32-2] 728-2111 (954) 845-2600 Tech. Support Service

1/03

UDC 6300 Process Controller Product Manual

iii

Symbol Definitions

!

This CAUTION symbol on the equipment refers the user to the Product Manual for additional information. This symbol appears next to required information in the manual.

WARNING, risk ofelectric shock. This symbol warns the user of a potential shock hazard where HAZARDOUS LIVE voltages greater than 30 Vrms, 42.4 Vpeak, or 60 Vdc may be accessible.

Protective earth terminal. Provided for connection of the protective earth (green or green/yellow) supply system conductor.

iv

UDC 6300 Process Controller Product Manual

1/03

Table of Contents

SECTION 1 –OVERVIEW.................................................................................................. 1 1.1 Introduction................................................................................................... 1 1.2 Operator Interface ........................................................................................ 4 SECTION 2 –INSTALLATION........................................................................................... 7 2.1 2.2 2.3 2.4 2.5 2.6 Overview....................................................................................................... 7 Model Number Interpretation........................................................................ 9 Preliminary Installation Procedure .............................................................10...