Mecanismo escalera panasonic

[pic]11 Assembling and Disassembling the Mechanism unit 11.1 Replacement for DVD traverse deck [pic][pic]11.2 Replacement for optical pickup unit (CD mechanism)[pic][pic][pic][pic][pic][pic][pic][pic][pic][pic][pic][pic][pic][pic]11.3 Assembling for traverse motor and spindle motor [pic][pic][pic][pic][pic][pic][pic]11.4 Procedure for removing DVD loading mechanism
1. Turn off by pressingpower SW in the body.
2. Unplug AC power cord after the indication of [GOOD-BYE], then disassemble the body.
3. Disassemble the body, and take out DVD loading mechanism.
4. Performdisassembly according to the following procedure for disassembly.
11.5 CR16 mechanism disassembly procedure 11.5.1 Gear for servicing information
• This unit has a gear which used for checking items(open/close of disc tray, up/down operation of traverse unit by manually) when servicing. (For gear information, that is described on the items for disassembly procedures.)
• For preparation of gear(for servicing), perform the procedures as follows.
• In case of re-servicing the same set, the “gear for servicing” may be took off because it had been used. So, the “gear for servicing” must bestored.
1. Remove the gear attached to top cover of DVD loading mechanism.
[pic]
2. Insert the hexagonal wrench (2.5mm) into the gear.
[pic]
11.5.2 Replacement for the disctray [pic][pic][pic][pic][pic][pic][pic][pic]11.5.3 Replacement for the traverse deck
• Follow the (Step 1) - (Step 10) of item 11.5.2.
[pic][pic][pic]11.5.4 Disassembly for DVD loading unit
•Follow the (Step 1) - (Step 10) of item 11.5.2.
• Follow the (Step 1) - (Step 4) of item 11.5.3.
[pic][pic][pic][pic][pic][pic][pic][pic][pic][pic][pic][pic][pic][pic][pic][pic][pic]11.6 CR16MECHANISM ASSEMBLY PROCEDURE The following specified greases and/or oil must be applied when some specific parts are changed.
1. Floil grease (VFK1298): The floil grease must be applied to tray,...