Mecatronica

Lathe Professional Courseware

To order more books: Call 1-800-529-5517 or Visit www.emastercam.com or Contact your Mastercam dealer

Mastercam X6 Lathe - Professional Courseware Copyright: 1998 - 2011 In-House Solutions Inc. All rights reserved Software: Mastercam X6 Author: Mariana Lendel ISBN: 978-1-926955-50-6 Revision Date: February 17, 2012 Notice In-House Solutions Inc. reserves theright to make improvements to this manual at any time and without notice. Disclaimer Of All Warranties And Liability In-House Solutions Inc. makes no warranties, either express or implied, with respect to this manual or with respect to the software described in this manual, its quality, performance, merchantability, or fitness for any particular purpose. In-House Solutions Inc. manual is sold orlicensed "as is." The entire risk as to its quality and performance is with the buyer. Should the manual prove defective following its purchase, the buyer (and not In-House Solutions Inc., its distributer, or its retailer) assumes the entire cost of all necessary servicing, repair, of correction and any incidental or consequential damages. In no event will In-House Solutions Inc. be liable fordirect, indirect, or consequential damages resulting from any defect in the manual, even if In-House Solutions Inc. has been advised of the possibility of such damages. Some jurisdictions do not allow the exclusion or limitation of implied warranties or liability for incidental or consequential damages, so the above limitation or exclusion may not apply to you. Copyrights This manual is protectedunder International copyright laws. All rights are reserved. This document may not, in whole or part, be copied, photographed, reproduced, translated or reduced to any electronic medium or machine readable form without prior consent, in writing, from In-House Solutions Inc. Trademarks Mastercam is a registered trademark of CNC Software, Inc. Microsoft, the Microsoft logo, MS, and MS-DOS areregistered trademarks of Microsoft Corporation; N-See is a registered trademark of Microcompatibles, Inc.; Windows, Windows XP, Windows Vista, Windows NT and Windows 7 are registered trademarks of Microsoft Corporation.

Lathe Professional Courseware Contents
2D Geometry ............................................................................................................... 1
Overview OfThe Graphical User Interface ................................................................................................ 2 Create Point Position Command ............................................................................................................. 15 Create Rectangle & Rectangular Shapes Commands............................................................................... 16Create Line Endpoints & Line Parallel Commands .................................................................................. 17 Create Fillet Entities & Fillet Chain Commands........................................................................................ 18 Edit Trim/ Extend Commands................................................................................................................. 20 Xform Mirror Command........................................................................................................................... 20 Edit Break Command ............................................................................................................................... 29 Edit Join Command................................................................................................................................. 30 Create Chamfer Entities & Chamfer Chain .............................................................................................. 31 Xform Offset & Offset Chain ................................................................................................................... 36 Create Arc Circle Center Point & Arc Endpoints...