Microcontrolador

Remove CP
Remove the code protection in some cases, it depends if the code
protection was installed in the program or while programming.
Erase PIC
Deletes the program or code in the connected PIC.
Blank check
Check if the PIC’s memory is empty
Write HEX-File into PIC
Writes the program previously loaded with the Select HEX-File as
source option, into the connected PIC.
Compare PIC withHEX-File
Compares the content of the memory with the previously loaded
program.
Before using your
Before using your new USB port PIC programmer please read this
programmer
instruction
instruction manual to prevent any damage. Put it away in a safe
any damage.
away in
place
place for future references.
references.

•
•
•

WARNING
To avoid damaging your programmer, please ensurepins are
connected to the correct side.
Do not place the PIC-600 over metallic surfaces.
Do not place metallic objects over the programmer

Read from PIC into new HEX-File
Reads the Pic’s memory and save into a new .HEX file, you must enter
a name and location for the file.
Target: Run
Use this option to switch the PIC to run mode after programming it into
the ICSP port. Be careful toinsulate the ICSP port from the rest of the
circuit where the PIC is installed.

SPECIFICATIONS
DRIVER INSTALLATION IN WINDOWS XP
5V
(through USB port)
1.- Place the installation CD into the CD-ROM drive.
2.- AS part of the content of the disc, you will find the folder PIC-600, it
Product design and specifications are subject to change without
change
Product design
subject
contains driverand software folders.
previous notice.
previous notice.
3.- Copy the folder PIC-600 and its content into the hard disk. Do not
forget the location, you will use it later.
4.- Use a USB cable type B (USB-450) to connect the programmer to
computer.
5.- The computer will detect the new hardware, the Found New
Hardware Wizard runs.
6.- Select No, not this time and click Next to continue.
7.-Now select Search for the best driver in these locations, click Next to
Product: USB port PIC programmer
continue.
Part number: PIC-600
Brand: Steren
8.- Click on Browse to find the folder Driver. Then click Next to continue.
9.- The installation process begins. If a warning message pop up,
please click OK to continue.
WARRANTY
This Steren product is warranted under normal usage againstdefects in workmanship and materials to the
10.- The completed installation window will appear shortly afterwards,
original purchaser for one year from the date of purchase.
just click on Finish.
Do
installing drivers, may
Do not place any PIC on the base while installing drivers, may
any PIC
cause damages
cause damages on it.
it.
The
Vista.
The software have not drivers for WindowsVista.
In Windows Vista, the softawre will run changing the compatibility
changing the compatibility
mode
mode to Windows Xp SP2.
Xp SP2.
OPERATION
IMPORTANT
Before to run the software, it is recommendable to connect the PIC
software, it
first, and then open the software, otherwise the software may not
may not
recognize
recognize the programmer.
programmer.

CONDITIONS
1.- Thiswarranty card with all the required information, invoice or purchase ticket, product box or package,
and product, must be presented when warranty service is required.
2.- If the product stills on the warranty time, the company will repair it free of charge.
3.- The repairing time will not exceed 30 natural days, from the day the claim was received.
4.- Steren sell parts, components, consumables andaccesories to costumer, as well as warranty service, at
any of the addresses mentioned later.
THIS WARRANTY IS VOID IN THE NEXT CASES:
If the product has been damaged by an accident, acts of God, mishandling, leaky batteries, failure to follow
enclosed instructions, improper repair by unauthorized personnel, improper safe keeping, among others.
a) The consumer can also claim the warranty...