Montaje Antenas 1.8

1.8 m Compact Antenna
Installation Instruction

MINI-LINK

TM

1.8 m Compact Antenna
Installation Instruction

Copyright © Ericsson AB 2006 – All rights reserved. No parts of this publication may be reproduced, stored in a retrieval system, or transmitted in any form or by any means, electronic, mechanical, photocopying, recording or otherwise, without prior permission of thepublisher. Disclaimer The contents of this document are subject to revision without notice due to continued progress in methodology, design, and manufacturing. Ericsson shall have no liability for any error or damage of any kind resulting from the use of this document.

2/1531-COH 901 090/1 Uen H 2006-08-31

Contents

Contents
1 1.1 1.2 1.3 2 2.1 2.2 2.3 2.4 2.5 3 3.1 3.2 4 4.1 4.2 4.3 4.4 4.5 55.1 5.2 5.3 6 7 7.1 7.2 8 9 Introduction Target Group Revision Information Related Documents Safety Instructions Introduction Standards Safety Requirements Safety Symbols and Definitions Hazards Tools and Equipment Tools Equipment Assembly Procedure Preparations Assembling Antenna and Shield Panels Fitting the Feeder Fitting the Radome Assembling the Antenna Mount Installation Procedure Fittingthe Antenna Side Strut Installation Fitting the Radio Unit Radio Cable Installation Antenna Alignment and Software Setup Alignment Procedure Software Setup Tightening Procedure Repair Handling 1 2 2 2 3 3 3 5 6 7 11 11 12 15 15 18 21 28 33 39 39 44 46 49 51 51 54 55 59

2/1531-COH 901 090/1 Uen H 2006-08-31

1.8 m Compact Antenna

9.1

Shipping Instructions

59

2/1531-COH 901 090/1 UenH 2006-08-31

Introduction

1

Introduction
This instruction describes how to assemble and install a 1.8 m compact antenna (6 ft). The instruction applies to the RAU1 and RAU2 radio units. Only installation procedure for RAU2 is described, since the procedure for RAU1 is similar. The high performance antenna is illustrated, but the instruction also applies to a standard performanceantenna.

RADIO CABLE

RADIO CABLE

ALARM

POWER

ALIGNME NT

9019

Figure 1

1.8 m Compact Antenna (6 ft)

In general, a right-side installation is described, though it is possible to choose a left-side installation as well.

2/1531-COH 901 090/1 Uen H 2006-08-31

1

1.8 m Compact Antenna

1.1

Target Group
This manual is targeted at the personnel (installationtechnicians) who work with the installation of MINI-LINK equipment on site. The personnel must be authorized and have appropriate technical training and experience. The personnel is expected to be experienced in radio and mobile communications and have basic understanding of technical English or any other language in which this manual is available.

1.2

Revision Information
The following changes havebeen made since the last release. • • The installation instructions in section 4.3 “Fitting the Feeder” have been updated to include the AXR 7-13 GHz feeders. The illustrations in section 4.3 “Fitting the Feeder” have been updated to include the AXR 7-13 GHz feeders.

1.3

Related Documents
The following documents contain information related to the 1.8 m compact antenna. These documents arereferred to using document names only. Note: Table 1 Product numbers starting with EN/LZT are in A4 size and product numbers starting with AE/LZT are in Letter size. Related Documents
EN/LZT 712 0015 AE/LZT 712 0015

MINI-LINK TN, MINI-LINK HC, MINI-LINK E Outdoor Installation Manual

2

2/1531-COH 901 090/1 Uen H 2006-08-31

Safety Instructions

2
2.1

Safety InstructionsIntroduction
This section describes the system used for presenting safety information. Note: Reduce the risk of accidents by studying all the instructions carefully before you start working. Should questions arise regarding the safety instructions, contact your supervisor or your local Ericsson representative.

The relevant manual (including this safety information) and specific instructions supplied...