Msm Keke

Installation Guide
Avigilon Panoramic High Definition IP Dome Camera Model:
8.0MP-HD-DOME-360
920-0015A-Rev2

Important Safety Information
This manual provides installation and operation information and precautions for the use of this dome camera. Incorrect installation could cause an unexpected fault. Before installing this equipment read this manual carefully. Please provide this manualto the owner of the equipment for future use. The Warning symbol indicates the presence of dangerous voltage within and outside the product enclosure that may constitute a risk of electric shock, serious injury or death to persons if proper precautions are not followed. The Caution symbol alerts the user to the presence of hazards that may cause minor or moderate injury to persons, damage toproperty or damage to the product itself if proper precautions are not followed.

Warning — Failure to observe the following instructions
may result in severe injury or death. • • • Do not use near water or expose to dripping or splashing. Do not place objects filled with liquids above the device. Do not expose to rain or moisture. For indoor use only. If used outdoors, an approved outdoor mountingadapter or enclosure is required. Consult with Avigilon for more information. Installation must be performed by qualified personnel only, and must conform to all local codes. This product is intended to be supplied by a UL Listed Power Unit marked “Class 2” or “LPS” or “Limited Power Source” with output rated 12 VDC or 24 VAC, 7 W min. or Power over Ethernet (PoE), rated 48 VDC, 7 W min. i

• •English English

English English

•

•

Any external power supply connected to this product may only be connected to another Avigilon product of the same model series. External power connections must be properly insulated. Do not connect directly to mains power for any reason.

Caution — Failure to observe the following instructions
may result in injury or damage to the dome camera.• • • • Do not install near any heat sources such as radiators, heat registers, stoves, or other sources of heat. Do not subject the cables to excessive stress, heavy loads or pinching. Do not open or disassemble the device. There are no user serviceable parts. Refer all servicing to qualified personnel. Servicing may be required when the device has been damaged (such as from a liquid spill orfallen objects), has been exposed to rain or moisture, does not operate normally, or has been dropped. Do not use strong or abrasive detergents when cleaning the device body. Use only accessories recommended by Avigilon. Avoid leaving the image sensor exposed for extended periods of time. Always cover the image sensor with either a lens or a dust cap. Do not allow dust, moisture or any other foreigndebris to enter the lens mount. Never touch any glass elements inside the lens mount. Do not point the lens directly at the sun or other extremely bright objects or damage to the image sensor may occur. Use of controls or adjustments or performance of procedures other than those specified in this document may result in hazardous radiation exposure.

• • •

• • • •

ii

Regulator NoticesThis device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This product complies with IEC 60825-1 (A2:2001) - CLASS 1 LED PRODUCT. Maximum radiated output power: 740 mW. This Class Adigital apparatus complies with Canadian ICES-003.

FCC Notice
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate...