Nana
Dump truck
Assembly
Instructions
View of completed model
* This model was designed for
Papercraft and may differ from
the original in some respects.
ToolsA ssembly tip
Scissors
Ruler, set square
Glue (Wood glue or craft glue recommend)
Exhausted ballpoint pen (out of ink)
Toothpicks (for use in applying glue)
Tweezers (useful for handlingsmall parts)
Pencil
Write the number of each part on the reverse side of the part in pencil
upon cutting it out, to be sure you can tell which part is which later.
Before gluing, crease the paperalong
mountain and valley fold lines. Trace along
the folds with a ruler and an exhausted
ballpoint pen (out of ink) to get a sharper fold.
Make sure rounded sections are nice and stiff.
Key tosymbols
Pattern
Assembly instructions
Dotted line
Mountain fold
Fold so that the printed
pattern faces outside.
Dashed and
dotted line
Valley fold
Fold so that the printedpattern faces inside.
Solid line
Cut parts out
along this line.
The dots show where to glue
the pieces together. Glue the
pieces together as shown in the
following examples.
Some parts mustbe glued
together along the cut surfaces.
Red dot
Glue parts with the same
number together. (Numbers are
not printed on very small parts.)
Solid red line
Diagonal
grey lines
Cut anotch
along this line.
Green dot
Cut these areas
out.
Blue dot
Glue areas within the same
part together.
Glue to the reverse side of the
specified part.
Glue, scissors and othertools may be dangerous to young children
so be sure to keep them out of the reach of young children.
Assembly Instructions: Ten A4 sheets (No. 1 to No. 10)
Build this model with careful reference tothe Assembly Instructions.
Red arrow
Blue arrow
Glue
Insert
(without gluing)
Light blue
Glue tab
Light grey
Reverse side of
paper
Movable part
This denotes a part
that must...
Regístrate para leer el documento completo.