Ninguno

This publication, including photographs, illustrations and software, is under the protection of international copyright laws, with all rights reserved. Neither this manual, nor any of the material contained herein, may be reproduced without the express written consent of the manufacturer.
The information in this document is subject to change without notice. The manufacturer makes norepresentations or warranties with respect to the contents hereof and specifically disclaims any implied warranties of merchantability or fitness for any particular purpose. Further, the manufacturer reserves the right to revise this publication and to make changes from time to time in the content hereof without obligation of the manufacturer to notify any person of such revision or changes.

TrademarksIBM, VGA, and PS/2 are registered trademarks of International Business Machines.
Intel, Pentium, Pentium-II, Pentium-III, Pentium 4, MMX, Celeron and Tualatin are registered trademarks of Intel Corporation.
Microsoft, MS-DOS and Windows 98/ME/NT/2000/XP are registered trademarks of Microsoft Corporation.
PC-cillin is a trademark of Trend Micro Inc.
AMI is a trademark of American MegatrendsInc.
It has been acknowledged that all mentioned brands or product names are trademarks or registered trademarks of their respective holders.






Copyright © 2004
All Rights Reserved
M925G Series, V9.1B
P4M266A/March 2004


Table of Contents

Trademark I
Static Electricity Precautions III
Pre-Installation Inspection III
Features & Checklist Translations V

Chapter 1:Introduction 1
Key Features 2
Package Contents 6
Chapter 2: Motherboard Installation 7
Motherboard Components 8
I/O Ports 8
Installing the Processor 9
Installing Memory Modules 10
Jumper Settings 12
The Panel Connector 13
Other Devices Installation 14
Expansion Slots Installation 14
Connecting Optional Devices 15
Chapter 3: BIOS Setup Utility 18Introduction 18
Running the Setup Utility …………………………...19
Standard CMOS Setup Page 20
Advanced Setup Page 21
Power Management Setup Page 24
PCI/Plug and Play Setup Page 26
Load Optimal Settings 27
Load Best Performance Settings 27
Features Setup Page 27
CPU PnP Setup Page 29
Hardware Monitor Page 29
Change Password 30
Exit 30
Chapter 4: Software &Applications 31
Introduction 31
Installing Support Software 32
Bundled Software Installation 34
Hyper-Threading CPU 35


Static Electricity Precautions

Static electricity could damage components on this motherboard. Take the following precautions while unpacking this motherboard and installing it in a system.
1. Don’t take this motherboard and components out of their originalstatic-proof package until you are ready to install them.
2. While installing, please wear a grounded wrist strap if possible. If you don’t have a wrist strap, discharge static electricity by touching the bare metal of the system chassis.
3. Carefully hold this motherboard by its edges. Do not touch those components unless it is absolutely necessary. Put this motherboard on the top ofstatic-protection package with component side facing up while installing.

Pre-Installation Inspection

1. Inspect this motherboard whether there are any damages to components and connectors on the board.
2. If you suspect this motherboard has been damaged, do not connect power to the system. Contact your motherboard vendor about those damages.
Notice:
1. Owing to Microsoft’s certifying schedule isvarious to every
supplier, we might have some drivers not certified yet by
Microsoft. Therefore, it might happen under Windows XP that a
dialogue box (shown as below) pops out warning you this
software has not passed Windows Logo testing to verify its
compatibility with Windows XP. Please rest assured that our RD
department has already tested and verified these drivers....