No es util este archivo

ENUWI-G2 ENCORE 802.11g Wireless USB Adapter

User’s Manual

FCC Certifications
Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that If this equipment does cause interference will not occur in a particular installation.

harmful interference to radio or television reception, which can bedetermined by turning the equipment off and on, the user is encouraged to try to correct the interference by one of the following measures: -Reorient or relocate the receiving antenna. -Increase the separation between the equipment and receiver. -Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. -Consult the dealer or an experienced radio/TVtechnician for help. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliancecould void the user's authority to operate this equipment. IMPORTANT NOTE: FCC Radiation Exposure Statement: This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator & your body. This transmitter must not be co-located or operating in conjunction with anyother antenna or transmitter. IEEE 802.11b or 802.11g operation of this product in the U.S.A. is firmware-limited to channels 1 through 11.

1

CE Mark Warning
This equipment complies with the requirements relating to electromagnetic compatibility, EN 55022 Class B for ITE, the essential protection requirement of Council Directive 89/336/EEC on the approximation of the laws of the MemberStates relating to electromagnetic compatibility. Company has an on-going policy of upgrading its products and it may be possible that information in this document is not up-to-date. Please check with your local distributors for the latest information. No part of this document can be copied or reproduced in any form without written consent from the company.

Trademarks: All trade names andtrademarks are the properties of their respective companies. Copyright © Encore Electronics, Inc. 2007, All Rights Reserved.

2

TABLE OF CONTENTS
OVERVIEW.................................................... 4
UNPACKING INFORMATION ....................................................... 4 INTRODUCTION TO ENCORE 802.11G WIRELESS USB ADAPTER ..... 5
Key Features.....................................................................................5

INSTALLATION GUIDE .................................. 6
SOFTWARE INSTALLATION ........................................................ 6

MANAGEMENT GUIDE ................................. 11
MAKING A BASIC NETWORK CONNECTION .................................. 11
Before You Start..............................................................................11 Ad-Hoc Mode ................................................................................. 11 Infrastructure mode ....................................................................... 13

INTRODUCTION TO THE WIRELESS LAN UTILITY ......................... 15
Starting the Wireless LAN Utility .....................................................15...