Osciloscopio 2542

General Safety Summary 

General Safety Summary

User Manual
Digital Storage Oscilloscopes
Models 2534, 2540 & 2542

Review the following safety precautions to avoid injury and prevent damage to this product or any products connected to it. To avoid potential hazards, use this product only as specified. Only qualified personnel should perform service procedures. To Avoid Fire or PersonalInjury Use Proper Power Cord. Use only the power cord specified for this product and certified for the country of use. Connect and Disconnect Properly. Do not connect or disconnect probes or test leads while they are connected to a voltage source. Ground the Product. This product is grounded through the grounding conductor of the power cord. To avoid electric shock, the grounding conductor mustbe connected to earth ground. Before making connections to the input or output terminals of the product, ensure that the product is properly grounded. Connect the Probe Properly. The probe ground lead is at ground potential. Do not connect the ground lead to an elevated voltage. Observe All Terminal Ratings. To avoid fire or shock hazard, observe all ratings and marking on the product. Consultthe product manual for further ratings information before making connections to the product. Do Not Operate Without Covers. Do not operate this product with covers or panels removed. Avoid Exposed Circuitry. Do not touch exposed connections and components when power is present. Do Not Operate With Suspected Failures. If you suspect there is damage to this product, have it inspected by qualifiedservice personnel.

Version 1.03

 

General Safety Summary 

General Safety Summary 

Do Not Operate in Wet/Damp Conditions. Do Not Operate in an Explosive Atmosphere. Keep Product Surfaces Clean and Dry.

Symbols and Terms on the Product. Protective Ground (Earth) Terminal.

CAUTION. Refer to user manual. Caution indicates a hazard to property including this product

ContentsContents 
Contents .......................................................................................... 5 1. Getting Started ............................................................... 7 Inspect package content ...................................................... 7 Front Panel ............................................................................ 8 Rearpanel ........................................................................... 14 Interpreting the display ....................................................... 15 2. Basic Operation ........................................................... 17 Probe Compensation ......................................................... 17 Using Autoset ...................................................................... 18 VerticalControls .................................................................. 20 CH1, CH2 Menu .......................................................... 22 REF Function  .............................................................. 39 . Horizontal Controls ............................................................. 42 TriggerControls .................................................................. 55 ACQUIRE Menu .................................................................. 67 UTILITY Menu ..................................................................... 78 MEASURE Menu ................................................................ 91 SAVE/LOAD Menu ...........................................................  06 1 CURSOR Menu ................................................................  17 . 1 DISPLAY Menu .................................................................  23 1 RUN Controls ....................................................................  26 1 3. Application Examples  ...............................................  29 . 1 Make Simple Measurements ..........................................  29 1

Contents
Capture a Single-Shot...