Parameter Manual Sinamics G120C-Siemens

SINAMICS G120C

Parameter Manual · 01/2011

SINAMICS
s

s
Parameters
Function diagrams

SINAMICS

Faults and Alarms

SINAMICS G120C

Appendix
List of Abbreviations

Parameter Manual

Index

Valid for

Firmware version

SINAMICS G120C

4.4

A5E03052632B AA

01/2011

1
2
3
A
B
C

Safety Guidelines
This manual contains notices you have to observe inorder to ensure your personal safety, as well as to
prevent damage to property. The notices referring to your personal safety are highlighted in the manual
by a safety alert symbol, notices referring only to property damage have no safety alert symbol. These
notices shown below are graded according to the degree of danger.

Danger
indicates that death or severe personal injury will result ifproper precautions are not taken.

Warning
indicates that death or severe personal injury may result if proper precautions are not taken.

Caution
with a safety alert symbol, indicates that minor personal injury can result if proper precautions are not
taken.

Caution
without a safety alert symbol, indicates that property damage can result if proper precautions are not
taken.

Noticeindicates that an unintended result or situation can occur if the corresponding information is not taken into
account.
If more than one degree of danger is present, the warning notice representing the highest degree of danger will be used. A notice warning of injury to persons with a safety alert symbol may also include a warning
relating to property damage.

Qualified Personnel
Thedevice/system may only be set up and used in conjunction with this documentation. Commissioning
and operation of a device/system may only be performed by qualified personnel. Within the context of
the safety notes in this documentation qualified persons are defined as persons who are authorized to
commission, ground and label devices, systems and circuits in accordance with established safety practicesand standards.

Prescribed Usage of Siemens Products
Note the following:

Warning
This device may only be used for the applications described in the catalog or the technical description and
only in connection with devices or components from other manufacturers which have been approved or
recommended by Siemens.
Correct, reliable operation of the product requires proper transport, storage,positioning and assembly as
well as careful operation and maintenance.

Trademarks
All names identified by ® are registered trademarks of the Siemens AG. The remaining trademarks in this
publication may be trademarks whose use by third parties for their own purposes could violate the rights
of the owner.

Copyright Siemens AG 2011 All Rights Reserved

Disclaimer of Liability

Thedistribution and duplication of this document or the utilization and
transmission of its contents are not permitted without express written
permission. Offenders will be liable for damages. All rights, including
rights created by patent grant or registration of a utility model or
design, are reserved.

We have reviewed the contents of this publication to ensure
consistency with the hardware andsoftware described. Since
variance cannot be precluded entirely, we cannot guarantee full
consistency. However, the information in this publication is reviewed
regularly and any necessary corrections are included in subsequent
editions.

Siemens AG
Industry Sector
Postfach 4848
90327 NUREMBERG
GERMANY

Siemens Aktiengesellschaft

© Siemens AG 2011
Technical data subject to change.SINAMICS G120C Parameter Manual (LH13)

Contents
1

Parameters . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

1-7

1.1
1.1.1
1.1.2

1-8
1-8
1-15

1.2

List of Parameters . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

1-16

1.3
1.3.1
1.3.2
1.3.3
1.3.4

Command and Drive...