Placa geforce6100pm-m2

Preface
Copyright
This publication, including all photographs, illustrations and software, is protected under international copyright laws, with all rights reserved. Neither this manual, nor any of the material contained herein, may be reproduced without written consent of the author. Version 2.0A

Disclaimer
The information in this document is subject to change without notice. Themanufacturer makes no representations or warranties with respect to the contents hereof and specifically disclaims any implied warranties of merchantability or fitness for any particular purpose. The manufacturer reserves the right to revise this publication and to make changes from time to time in the content hereof without obligation of the manufacturer to notify any person of such revision orchanges.

Trademark Recognition
Microsoft, MS-DOS and Windows are registered trademarks of Microsoft Corp. nVIDIA is a registered trademark of nVIDIA Corporation Other product names used in this manual are the properties of their respective owners and are acknowledged.

Federal Communications Commission (FCC)
This equipment has been tested and found to comply with the limits for a Class Bdigital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guaranteethat interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: • • • • Reorient or relocate the receiving antenna Increase the separation between theequipment and the receiver Connect the equipment onto an outlet on a circuit different from that to which the receiver is connected Consult the dealer or an experienced radio/TV technician for help

Shielded interconnect cables and a shielded AC power cable must be employed with this equipment to ensure compliance with the pertinent RF emission limits governing this device. Changes ormodifications not expressly approved by the system’s manufacturer could void the user’s authority to operate the equipment.

Preface

ii

Declaration of Conformity
This device complies with part 15 of the FCC rules. Operation is subject to the following conditions: • • This device may not cause harmful interference, and This device must accept any interference received, including interferencethat may cause undesired operation

Canadian Department of Communications
This class B digital apparatus meets all requirements of the Canadian Interferencecausing Equipment Regulations. Cet appareil numérique de la classe B respecte toutes les exigences du Réglement sur le matériel brouilieur du Canada.

About the Manual
The manual consists of the following:

Chapter 1 Introducing theMotherboard

Describes features of the motherboard. Go to page 1

Chapter 2 Installing the Motherboard

Describes installation of motherboard components. Go to page 7

Chapter 3 Using BIOS

Provides information on using the BIOS Setup Utility. Go to page 27

Chapter 4 Using the Motherboard Software

Describes the motherboard software Go to page 49

Chapter 5 Setting Up NVIDIARAID Configuration

Provides information about SATA RAID Setup Go to page 55

Preface

iii

TABLE OF CONTENTS
Preface Chapter 1 i 1

Introducing the Motherboard 1 Introduction......................................................................................1 Feature...............................................................................................2 Motherboard...