Programador Plc S7 200

200Parameter List Edition 11/2004

sinamics
SINAMICS G110

SINAMICS G110 Documentation
Getting Started Guide The Getting Started Guide is designed to give the user quick access to all the basic information required to install and set-up the SINAMICS G110 for operation.

Operating Instructions Gives information regarding the features of SINAMICS G110 including Installation,Commissioning, Control modes, System Parameter structure, Troubleshooting, Specifications and available options for the inverter.

Parameter List The Parameter List contains a detailed description of all Parameters relating to the SINAMICS G110 and is structured in numerical order.

Catalogues In the catalogue you will find all the necessary information to select an appropriate inverter, aswell as the Basic Operator Panel and Communication Options for the SINAMICS G110 series.

Parameters

1

Faults and Alarms

2

Appendix

3

SINAMICS G110 120 W - 3 kW

Parameter List User Documentation

Inverter Type SINAMICS G110

Firmware Version 1.0 & 1.1 (on page 4)

Issue 11/2004

Important Information

11/2004

Important Information
This Parameter Listmust only be used in conjunction with the Operating Instructions of the SINAMICS G110. WARNING Please pay special attention to the Warnings, Cautions, Notices and Notes contained in the Operating Instructions. You will find the Operating Instructions on the Docu CD which can be ordered via your local Siemens department under the Order No. 6SL3271-0CA00-0AG0 or downloaded from our websitehttp://www.siemens.com/sinamics-g110.

Summary of amendments
Edition Valid for firmware version 1.0 1.0 Status/Changes Order no of the inverter 6SL3211-0xxxx-xxxx Last digit “0” 6SL3211-0xxxx-xxx0 Last digit “0” 6SL3211-0xxxx-xxx0 New features inserted: P0727: 2-wire / 3-wire control method P1234: DC braking start frequency P1236: Compound braking P1334: Slip compensation activationrange P2172: Threshold DC link voltage P1215-P1217: Motor holding brake optimized Last digit “1” 6SL3211-0xxxx-xxx1

04/2003 11/2004

First issue

1.1

Approved Siemens Quality for Software and Training is to DIN ISO 9001, Reg. No. 2160-01

Other functions not described in this document may be available. However, this fact shall not constitute an obligation to supply such functionswith a new control, or when servicing. We have checked that the contents of this document correspond to the hardware and software described. There may be discrepancies nevertheless, and no guarantee can be given that they are completely identical. The information contained in this document is reviewed regularly and any necessary changes will be included in the next edition. We welcomesuggestions for improvement. Siemens handbooks are printed on chlorine-free paper that has been produced from managed sustainable forests. No solvents have been used in the printing or binding process. Document subject to change without prior notice.

The reproduction, transmission or use of this document, or its contents is not permitted unless authorized in writing. Offenders will be liablefor damages. All rights including rights created by patent grant or registration of a utility model or design are reserved. © Siemens AG 2004. All Rights Reserved. SINAMICS® is a registered trademark of Siemens

Printed in the Federal Republic of Germany

Siemens-Aktiengesellschaft.

4

SINAMICS G110 Parameter List 6SL3298-0BA11-0BP0

11/2004

Table of Contents

Table ofContents
1 1.1 1.2 1.3 2 2.1 2.2 3 3.1 Parameters .............................................................................................................. 7 Introduction to SINAMICS G110 System Parameters .............................................. 7 Quick commissioning (P0010=1)............................................................................ 10 Parameter Description...