Redes

CONFIGURAR EL ROUTER:

Router>enable
//LEVANTAR PRIMERA INTERFAZ
Router#config t
Enter configuration commands, one per line. End with CNTL/Z.Router(config)#int f0/0
Router(config-if)#ip address 192.5.5.1 255.255.255.0
Router(config-if)#no shut
%LINK-3-UPDOWN: Interface Fastethernet0/0,changed state to up
%LINEPROTO-5-UPDOWN: Line protocol on Interface Fastethernet0/0, changed state to up
//LEVANTAR SEGUNDA INTERFAZRouter(config-if)#int f0/1
Router(config-if)#ip address 205.7.5.1 255.255.255.0
Router(config-if)#no shut
%LINK-3-UPDOWN: Interface Fastethernet0/1, changed state toup
%LINEPROTO-5-UPDOWN: Line protocol on Interface Fastethernet0/1, changed state to up
//CONFIGURAR PROTOCOLO DE RUTEAMIENTO Y LAS DOS SUBREDESRouter(config-if)#exit
Router(config)#router rip
Router(config-router)#network 192.5.5.0
Router(config-router)#network 205.7.5.0Router(config-router)#exit
Router(config)#exit
Router#copy run start
Building configuration...

[OK]
Router#

AGREGAR LA INTERFAZ SERIAL
lab_A#config t
Enterconfiguration commands, one per line. End with CNTL/Z.
lab_A(config)#int s0/0
lab_A(config-if)#ip address 201.100.11.1 255.255.255.0lab_A(config-if)#clock rate 6400
lab_A(config-if)#clock rate 64000
lab_A(config-if)#exit
lab_A(config)#router rip
lab_A(config-router)#network 201.100.11.0lab_A(config-router)#network 219.17.100.0
lab_A(config-router)#exit
lab_A(config)#exit
lab_A#copy run start
Building configuration...

[OK]
lab_A#